Search results
Results from the WOW.Com Content Network
It is a stepless, fully-automatic transmission, consisting of a V-shaped drive-belt, and two pulleys, each of two cones, whose effective diameter can be changed so that the "V" belt runs nearer the spindle or nearer the rim, depending on the separation of the cones. These are synchronized so that the belt always remains at the same optimal tension.
When the output disk is adjusted to a position equal to its own radius, the resulting drive ratio is 1:1. The drive ratio can be set to infinity (i.e. a stationary output disk) by moving the output disk to the center of the input disk. The output direction can also be reversed by moving the output disk past the center of the input disk.
The open belt drive has parallel shafts rotating in the same direction, whereas the cross-belt drive also bears parallel shafts but rotate in opposite direction. The former is far more common, and the latter not appropriate for timing and standard V-belts unless there is a twist between each pulley so that the pulleys only contact the same belt ...
Automated manual transmissions can be semi-automatic or fully-automatic in operation. Several different systems to automate the clutch and/or shifting have been used over the years, but they will generally use one of the following methods of actuation for the clutch and/or shifting: hydraulic or electro-hydraulic actuation, [12] electro-mechanical, [13] pneumatic, [6] [14] [15] electromagnetic ...
The Comet J11 was manufactured from 1954 to 1955. Engine: Villiers Mk 4F (98cc) (47mm x 57mm), Carburetor was a Villiers Type 6/0; Transmission: Two speed with clutch. Frame: Single down tube; Suspension: Front was lightweight telescopic fork, plastic gaiters. Rear was a plunger-type. Brakes: 4" front, 5" rear; Drive: Chain and sprocket
The clutch pedal controls the pressure plate (clutch engaged – the clutch pedal is not being pressed) or not connected to the engine (clutch disengaged – the clutch pedal is being pressed down). When the engine is running and the clutch is engaged (i.e., clutch pedal up), the flywheel spins the clutch pressure plate and hence the transmission.
Clutch control refers to the act of controlling the speed of a vehicle with a manual transmission by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts ...
The Comet radial was fairly standard with steel finned cylinders, cast light alloy cylinder heads and two valves per head. The valves are operated by a single rocker arms and push-rods, to the rear of the cylinder, which are in turn operated positively by inner and outer cam tracks operating rollers on the pushrod.