Search results
Results from the WOW.Com Content Network
In casting, a pattern is a replica of the object to be cast, used to form the sand mould cavity into which molten metal is poured during the casting process. Once the pattern has been used to form the sand mould cavity, the pattern is then removed, molten metal is then poured into the sand mould cavity to produce the casting.
The pins are then carefully pulled out of the sand. The critical part of the operation is to separate the cope and drag to remove the pattern. The pattern may be vibrated with a powered vibrator, or the pattern, and maybe the cope and drag flask, will be lightly tapped with a small hammer. The pattern is lifted from the sand, leaving a molding ...
When making a pattern it is best to taper the edges so that the pattern can be removed without breaking the mold. This is called draft . The opposite of draft is an undercut where there is part of the pattern under the mold material, making it impossible to remove the pattern without damaging the mold.
A 1928 book published by the Gorham Company, Famous Small Bronzes – A Representative Exhibit Selected from the Works of Noted Contemporary Sculptors, featured full page photographs of sculptures by such notable sculptors as: Chester Beach, Gutzon Borglum, Allan Clark, Cyrus Dallin, Abastenia St. Leger Eberle, Laura Gardin Fraser, Harriet ...
The making of patterns for casting; The making of patterns for sewing This page was last edited on 29 ...
Lost-foam casting (LFC) is a type of evaporative-pattern casting process that is similar to investment casting except foam is used for the pattern instead of wax. This process takes advantage of the low boiling point of polymer foams to simplify the investment casting process by removing the need to melt the wax out of the mold.
Evaporative-pattern casting is a type of casting process that uses a pattern made from a material that will evaporate when the molten metal is poured into the molding cavity. The most common evaporative-pattern material used is polystyrene foam. [1] The two major evaporative-pattern casting processes are: [1] Lost-foam casting; Full-mold casting
Marking out (also known as layout) is the process of transferring a design or pattern to a workpiece and is the first step in the handcraft of metalworking. It is performed in many industries or hobbies, although in industry, the repetition eliminates the need to mark out every individual piece.