Search results
Results from the WOW.Com Content Network
For example, "five tenths," is typically a measurement or tolerance of five ten-thousandths of an inch, and written as 0.0005 inches. "Three tenths," as another example, is written as 0.0003 inches. [9] Machining "to within a few tenths" is often considered very accurate, and at or near the extreme limit of tolerance capability in most contexts.
[[Category:Record chart templates]] to the <includeonly> section at the bottom of that page. Otherwise, add <noinclude>[[Category:Record chart templates]]</noinclude> to the end of the template code, making sure it starts on the same line as the code's last character.
A logarithmic chart allows only positive values to be plotted. A square root scale chart cannot show negative values. x: the x-values as a comma-separated list, for dates and time see remark in xType and yType; y or y1, y2, …: the y-values for one or several data series, respectively. For pie charts y2 denotes the radius of the corresponding ...
Sometimes in official records, decimal hours were divided into tenths, or décimes, instead of minutes. One décime is equal to 10 decimal minutes, which is nearly equal to a quarter-hour (15 minutes) in standard time. Thus, "five hours two décimes" equals 5.2 decimal hours, roughly 12:30 p.m. in standard time.
In arithmetic, a hundredth is a single part of something that has been divided equally into a hundred parts. [1] For example, a hundredth of 675 is 6.75. In this manner it is used with the prefix "centi-" such as in centimeter.
The codes given in the chart below usually tell the length and width of the components in tenths of millimeters or hundredths of inches. For example, a metric 2520 component is 2.5 mm by 2.0 mm which corresponds roughly to 0.10 inches by 0.08 inches (hence, imperial size is 1008).
Creates a table row for a recognized single chart Template parameters [Edit template data] Parameter Description Type Status Chart identifier 1 Chart name: recognized values are listed at Template:Single chart/doc String required Chart position 2 Peak position on the chart Number required artist artist Artist name as listed on the source chart String required song song Song title as listed on ...
A similar template for use when citing sources for musical singles can be found at Template:Single chart; however, for EPs or other releases, it has not yet been developed. In general, the template expands to produce a table row with the information country, record chart, reference, and peak position for the given album on the particular chart ...