Search results
Results from the WOW.Com Content Network
Non-shrink grout is a hydraulic cement grout that, when hardened under stipulated test conditions, does not shrink, so its final volume is greater than or equal to the original installed volume. It is often used as a transfer medium between load-bearing members.
A normal-size fiber for European shotcrete (1 mm diameter, 45 mm length—steel or plastic) will increase the concrete's tensile strength. Fiber reinforcement is most often used to supplement or partially replace primary rebar, and in some cases it can be designed to fully replace rebar.
Portland cement is the most common type of cement in general use around the world as a basic ingredient of concrete, mortar, stucco, and non-specialty grout. It was developed from other types of hydraulic lime in England in the early 19th century by Joseph Aspdin , and is usually made from limestone .
Grout joints are traditionally about 3 ⁄ 8 inch in width. Matching trim shapes such as coves , bases, shoes, and bullnoses are available to turn corners and terminate runs of the tile. For traditional/historic applications, tiles were generally laid in lime mortar, doubling as grout, and with very fine grout joints (sometimes butted without ...
Grout sealer is a water-based or solvent-based sealant applied over dried grout that resists water, oil, and acid-based contaminants. Grout cleaner is a basic cleaning solution that is applied on grout lines and removes the dirt and dust. [9] A die grinder is used for faster removal of old grout compared to a standard grout saw.
The alternating stairs (3) requires one unit of space per step: the same as the half-width stairs (2), and half as much as the full-width stairs (1). Thus, the horizontal distance between steps is in this case reduced by a factor of two, reducing the size of each step.
Pressure grouting or jet grouting [1] involves injecting a grout material into otherwise inaccessible but interconnected pore or void space of which neither the configuration or volume are known, and is often referred to simply as grouting. The grout may be a cementitious, resinous, or solution chemical mixture. Some types of injected grout may ...
This joint is best used when the wall is intended to be plastered or joints are to be hidden under paint. Because the mortar is not compressed, it is less water-resistant than some of the other designs. Tuckpointing This joint has mortar colored to match the bricks surrounding a line of white mortar to make the joints look very small.