Search results
Results from the WOW.Com Content Network
Trickle charging is the process of charging a fully charged battery at a rate equal to its self-discharge rate, enabling the battery to remain at its fully charged level. This state occurs almost exclusively when the battery is not loaded, as trickle charging will not keep a battery charged if current is being drawn by a load.
Qi (/ tʃ iː / CHEE) is an open standard for inductive charging developed by the Wireless Power Consortium.It allows compatible devices, such as smartphones, to receive power when placed on a Qi charger, which can be effective over distances up to 4 cm (1.6 in). [1]
Float voltage is the voltage at which a battery is maintained after being fully charged to maintain that capacity by compensating for self-discharge of the battery. [1] The voltage could be held constant for the entire duration of the cell's operation (such as in an automotive battery) or could be held for a particular phase of charging by the charger. [2]
The primary coil in the charger induces a current in the secondary coil in the device being charged. Inductive charging (also known as wireless charging or cordless charging) is a type of wireless power transfer. It uses electromagnetic induction to provide electricity to portable devices. Inductive charging is also used in vehicles, power ...
Quick Charge 2.0 introduced an optional feature called Dual Charge (initially called Parallel Charging), [4] using two PMICs to split the power into 2 streams to reduce phone temperature. [5] Quick Charge 3.0 introduced INOV (Intelligent Negotiation for Optimal Voltage), Battery Saver Technologies, HVDCP+, and optional Dual Charge+. INOV is an ...
Case A: any charger connected to the mains (the mains supply cable is usually attached to the charger) usually associated with modes 1 or 2. Case B: an on-board vehicle charger with a mains supply cable that can be detached from both the supply and the vehicle – usually mode 3. Case C: DC dedicated charging station. The mains supply cable may ...
A simple charger typically does not alter its output based on charging time or the charge on the battery. This simplicity means that a simple charger is inexpensive, but there are tradeoffs. Typically, a carefully designed simple charger takes longer to charge a battery because it is set to use a lower (i.e., safer) charging rate.
SAE J1772, also known as a J plug or Type 1 connector after its international standard, IEC 62196 Type 1, is a North American standard for electrical connectors for electric vehicles maintained by SAE International under the formal title "SAE Surface Vehicle Recommended Practice J1772, SAE Electric Vehicle Conductive Charge Coupler".