Search results
Results from the WOW.Com Content Network
First, a static pressure gauge is attached to the test hydrant and the static water pressure is measured at the test hydrant. Second, the flow hydrant opened to allow water to flow in a fully open condition. Simultaneously the pitot tube pressure is recorded from the flow hydrant while the residual pressure is measured from the test hydrant.
The test involves filling the vessel or pipe system with a liquid, usually water, which may be dyed to aid in visual leak detection, and pressurization of the vessel to the specified test pressure. Pressure tightness can be tested by shutting off the supply valve and observing whether there is a pressure loss.
A trap primer (or trap seal primer) is a plumbing device or valve that adds water to traps.The water seals in traps are needed to prevent sewer gases from entering buildings, but because this water is exposed to the air, it is subject to evaporation over time in infrequently used floor drains, leading to the release of sewer gas into the environment.
Internal parts of a typical globe valve. The body is the main pressure-containing structure of the valve and the most easily identified as it forms the mass of the valve.It contains all of the valve's internal parts that will come in contact with the substance being controlled by the valve.
Water cannot flow from the sink to the tap in normal circumstances, even if the water supply loses pressure. An air gap, as related to the plumbing trade, is the unobstructed vertical space between the water outlet and the flood level of a fixture. [1]
An ionizing bar, sometimes referred to as a static bar, is a type of industrial equipment used for removing static electricity from a production line to dissipate static cling and other such phenomena that would disrupt the line. It is important in the manufacturing and printing industries, although it can be used in other applications as well.
Pool drain vortex as viewed from above the water at Grange Park wading pool Underwater view of drain, showing vortex-formation phenomenon. A drain is the primary vessel or conduit for unwanted water or waste liquids to flow away, either to a more useful area, funnelled into a receptacle, or run into sewers or stormwater mains as waste discharge to be released or processed.
where and are contact and channel resistances, respectively, / is the channel length/width, is gate insulator capacitance (per unit of area), is carrier mobility, and and are gate-source and drain-source voltages. Therefore, the linear extrapolation of total resistance to the zero channel length provides the contact resistance.