Search results
Results from the WOW.Com Content Network
English: In a typical leaded bell-and-spigot joint, the spigot is inserted into the bell of another pipe, yarn or oakum is compressed into the space, then hot lead was poured and also worked into the joint. Installers would typically use a set of tools, with different sized heads, to make sure both the yarn and lead were properly worked into ...
In a bell and spigot joint [2] one end of the pipe stick is flared, termed the bell or socket, to enable the opposite end of the next stick, the spigot end, to be inserted to create a joint. The gaps in these joints were stuffed with oakum or yarn to retain molten-lead, which solidified into a waterproof joint.
A threaded pipe has a screw thread at one or both ends for assembly. Steel pipe is often joined with threaded connections; tapered threads are cut into the end of the pipe, and sealant is applied in the form of thread-sealing compound or thread seal tape (also known as PTFE or Teflon tape) and the pipe is screwed into a threaded fitting with a ...
The spigot end will fit inside the bell end of the next pipe section. It is important to know which one of these you are referring to because this will change the desired results of what you are measuring. Measurement should be taken from the bottom of the bell end. This will be the lowest point of the pipe, and also where the water will flow. [6]
Spigot and sockets involve a normal pipe end, the spigot, being inserted into the socket or bell of another pipe or fitting with a seal being made between the two within the socket. Normal spigot and socket joints do not allow direct metal to metal contact with all forces being transmitted through the elastomeric seal.
While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...
A pipe support or pipe hanger is a designed element that transfer the load from a pipe to the supporting structures. The load includes the weight of the pipe proper, the content that the pipe carries, all the pipe fittings attached to pipe, and the pipe covering such as insulation. The four main functions of a pipe support are to anchor, guide ...
Vitrified clay pipe (VCP) is pipe made from a blend of clay and shale that has been subjected to high temperature to achieve vitrification, which results in a hard, inert ceramic. VCP is commonly used in gravity sewer collection mains because of its long life and resistance to almost all domestic and industrial sewage , particularly the ...