Search results
Results from the WOW.Com Content Network
The Erweka tester tests a tablet placed on the lower anvil and a weight moving along a rail transmits pressure slowly to the tablet. [5] The Dr.Schleuniger Pharmatron tester operates in a horizontal position. An electric motor drives an anvil to compress a tablet at a constant rate. The tablet is pushed against a stationary anvil until it ...
Download as PDF; Printable version; ... Pages in category "Hardness tests" The following 27 pages are in this category, out of 27 total. ... Knoop hardness test;
A Rockwell hardness tester. The Rockwell hardness test is a hardness test based on indentation hardness of a material. The Rockwell test measures the depth of penetration of an indenter under a large load (major load) compared to the penetration made by a preload (minor load). [1]
Scratch hardness. The Mohs scale of mineral hardness; The Vickers hardness test; The Brinell scale; The Janka hardness test; The Rockwell scale; The Durometer scale; The Barcol scale; The Leeb rebound hardness scale; The Rosiwal scale; The Meyer hardness test; The Knoop hardness test
The basic test requires applying the force in a consistent manner, without shock, and measuring the hardness (depth of the indentation). If a timed hardness is desired, force is applied for the required time and then read. The material under test should be a minimum of 6 mm (0.25 inches) thick. [3]
A variety of hardness-testing methods are available, including the Vickers, Brinell, Rockwell, Meyer and Leeb tests. Although it is impossible in many cases to give an exact conversion, it is possible to give an approximate material-specific comparison table for steels.
The Meyer hardness test is a hardness test based upon projected area of an impression. The hardness, H {\displaystyle H} , is defined as the maximum load, P max {\displaystyle P_{\text{max}}} divided by the projected area of the indent, A p {\displaystyle A_{\text{p}}} .
When testing coatings, scratch hardness refers to the force necessary to cut through the film to the substrate. The most common test is Mohs scale, which is used in mineralogy. One tool to make this measurement is the sclerometer. Another tool used to make these tests is the pocket hardness tester. This tool consists of a scale arm with ...