Search results
Results from the WOW.Com Content Network
A 50 mm (focal length) lens on an APS-C image sensor format (crop factor 1.6) images a slightly smaller field of view than a 70 mm lens on a 35 mm sensor format camera (full frame sensor). A 80 mm lens (1.6 × 50 mm = 80 mm) with a full frame camera gives the same field of view as this 50 mm lens and APS-C sensor format combination produces.
"NIST: Fundamental physical constants – Non-SI units" (PDF). Archived from the original (PDF) on 2016-12-27; NIST Guide to SI Units Many conversion factors listed. The Unified Code for Units of Measure; Units, Symbols, and Conversions XML Dictionary Archived 2023-05-02 at the Wayback Machine
Originally in 1945, the divisions were based on the ring inside diameter in steps of 1 ⁄ 64 inch (0.40 mm). [6] However, in 1987 BSI updated the standard to the metric system so that one alphabetical size division equals 1.25 mm of circumferential length. For a baseline, ring size C has a circumference of 40 mm. [7]
Although the most common medium format film, the 120 roll, is 6 cm (2.4 in) wide, and is most commonly shot square, the most common "medium-format" digital sensor sizes are approximately 48 mm × 36 mm (1.9 in × 1.4 in), which is roughly twice the size of a full-frame DSLR sensor format.
The film itself is 35 mm wide (1.38 in), but the area between the perforations is 24.89 mm × 18.67 mm (0.980 in × 0.735 in), leaving the de facto ratio of 1.33:1. [ 3 ] With a space designated for the standard optical soundtrack , and the frame size reduced to maintain an image that is wider than tall; this resulted in the Academy aperture of ...
This is a list of firearm cartridges that have bullets in the 9 millimeters (0.35 in) to 9.99 millimeters (0.393 in) caliber range. Case length refers to the round case length. OAL refers to the overall length of the loaded round. All measurements are given in millimeters, followed by the equivalent in inches between parentheses.
Throughout most of the world where the metric system is observed, guide numbers are expressed as a unitless numeric value like 34, even though they are technically a composite unit of measure that is a two-factor product: f‑number⋅meters. [6]
The quality of the edge can be mirror smooth and a precision of around 0.1 mm (0.0039 in) can be obtained. Cutting speeds on thin 1.2 mm (0.047 in) sheet can be as high as 25 m (82 ft) per minute.