Ads
related to: retaining wall design wood look
Search results
Results from the WOW.Com Content Network
As the setback of the wall increases, the size of the sliding wedge is reduced. This reduction lowers the pressure on the retaining wall. [4] The most important consideration in proper design and installation of retaining walls is to recognize and counteract the tendency of the retained material to move downslope due to gravity.
Asphalt and sandbag revetment with a geotextile filter. A revetment in stream restoration, river engineering or coastal engineering is a facing of impact-resistant material (such as stone, concrete, sandbags, or wooden piles) applied to a bank or wall in order to absorb the energy of incoming water and protect it from erosion.
Construction materials commonly used include wood pilings, commercially developed vinyl products, large boulders stacked to form a wall, or a seawall built of concrete or another hard substance. Coastal property owners typically seek to develop bulkheads in an attempt to slow large landslide erosion caused by wave action.
The weight of the stones resists the pressure from the retained soil, including any surcharges, and the friction between the stones causes most of them to act as if they were a monolithic gravity wall of the same weight. Dry stone retaining walls were once built in great numbers for agricultural terracing and also to carry paths, roads and ...
Cordwood masonry wall detail. The method is sometimes called stackwall because the effect resembles a stack of cordwood. A section of a cordwood home. Cordwood construction (also called cordwood masonry or cordwood building, alternatively stackwall or stovewood particularly in Canada) is a term used for a natural building method in which short logs are piled crosswise to build a wall, using ...
Soil nailing is a technique in which soil slopes, excavations or retaining walls are reinforced by the insertion of relatively slender elements – normally steel reinforcing bars. The bars are usually installed into a pre-drilled hole and then grouted into place or drilled and grouted simultaneously.
Typically in the form of a horizontal wire or rod, or a helical anchor, a tieback is commonly used along with other retaining systems (e.g. soldier piles, sheet piles, secant and tangent walls) to provide additional stability to cantilevered retaining walls. [1]
The walls were made of vertical half timbers; the outside, rounded half with its bark still on faced Adirondack weather, while the inside half was sanded and varnished for a finished wood look. Typically, the cracks between the vertical logs were filled with moss and sometimes covered with small sticks.
Ads
related to: retaining wall design wood look