Search results
Results from the WOW.Com Content Network
Port mirroring on a Cisco Systems switch is generally referred to as Switched Port Analyzer (SPAN) or Remote Switched Port Analyzer (RSPAN). Other vendors have different names for it, such as Roving Analysis Port (RAP) on 3Com switches. Network engineers or administrators use port mirroring to analyze and debug data or diagnose errors on a ...
For example, if an object represents four physical ports on an Ethernet switch, then it should not be possible to add or remove them from the data model. If an instance is added to an object, an identifier is assigned. After being assigned, identifiers cannot change during the life-cycle of the device, except by factory reset.
As sending monitor output through the network is bandwidth intensive, cards like AMI's MegaRAC use built-in video compression [2] (versions of VNC are often used in implementing this [3]). Devices like Dell DRAC also have a slot for a memory card where an administrator may keep server-related information independently from the main hard drive.
Modern Ethernet networks, built with switches and full-duplex connections, no longer need to use CSMA/CD, because each Ethernet segment, or collision domain, is now isolated. CSMA/CD is still supported for backwards compatibility and for half-duplex connections.
Bidirectional Forwarding Detection (BFD) is a network protocol that is used to detect faults between two routers or switches connected by a link.It provides low-overhead detection of faults even on physical media that doesn't support failure detection of any kind, such as Ethernet, virtual circuits, tunnels and MPLS label-switched paths.
EtherChannel between a switch and a server. EtherChannel is a port link aggregation technology or port-channel architecture used primarily on Cisco switches.It allows grouping of several physical Ethernet links to create one logical Ethernet link for the purpose of providing fault-tolerance and high-speed links between switches, routers and servers.
In the extreme case (i.e. micro-segmentation), each device is directly connected to a switch port dedicated to the device. In contrast to an Ethernet hub, there is a separate collision domain on each switch port. This allows computers to have dedicated bandwidth on point-to-point connections to the network and also to run in full-duplex mode.
On an IBM mainframe, a power-on reset (POR) is a sequence of actions that the processor performs either due to a POR request from the operator or as part of turning on power. The operator requests a POR for configuration changes that cannot be recognized by a simple System Reset .