Search results
Results from the WOW.Com Content Network
The kit is supported using PSoC Creator, which is a free IDE for embedded development targeting the PSoC 3/4/5LP device families. In the summer of 2013 Cypress supported the kit with a 100 projects in 100 days campaign on the community forums at Element14. Arduino Shield Compatible Propeller Board [265] Parallax Propeller: Parallax
A voltage regulator module (VRM), sometimes called processor power module (PPM), is a buck converter that provides the microprocessor and chipset the appropriate supply voltage, converting +3.3 V, +5 V or +12 V to lower voltages required by the devices, allowing devices with different supply voltages be mounted on the same motherboard.
For example, a temperature-controlled circulating bath has two PID controllers in cascade, each with its own thermocouple temperature sensor. The outer controller controls the temperature of the water using a thermocouple located far from the heater, where it accurately reads the temperature of the bulk of the water.
Temperature measuring and controlling module for microcontroller experiment. Temperature control is a process in which change of temperature of a space (and objects collectively there within), or of a substance, is measured or otherwise detected, and the passage of heat energy into or out of the space or substance is adjusted to achieve a desired temperature.
In atmospheric science, equivalent temperature is the temperature of air in a parcel from which all the water vapor has been extracted by an adiabatic process.
Reference voltage vs free-air temperature at test conditions. Design-center (middle plot) and worst-case deviation of ±2% (upper and lower plots) [ 12 ] The nominal reference voltage, V REF =2.495 V, stated in a datasheet, is tested in zener mode at an ambient temperature of +25 °C (77 °F), and I CA =10 mA. [ 13 ]
For instance, setting those up so that the temperature in the morning at 7 a.m. should be 21 °C (69.8 °F), makes sure that at that time the temperature will be 21 °C (69.8 °F), where a conventional thermostat would just start working at that time.
Heat sinks may be mounted externally or internally. Heat sinks are silent, whereas fans are more effective in cooling. Fan speed may adjust based on temperature or output current, the former of which cools faster while idle or low throughout intermittent power output, whereas the latter provides acoustic feedback of how much current is output ...