Ad
related to: dimension line vs extension wire outlet diagram
Search results
Results from the WOW.Com Content Network
The first types of small modular telephone connectors were created by AT&T in the mid-1960s for the plug-in handset and line cords of the Trimline telephone. [1] Driven by demand for multiple sets in residences with various lengths of cords, the Bell System introduced customer-connectable part kits and telephones, sold through PhoneCenter stores in the early 1970s. [2]
NEMA L6 connectors are rated for a maximum of 250 volts. They are intended for two-pole, three wire, line-line-earth (or hot-hot-ground) circuits with a nominal supply voltage of 208 or 240 volts, depending on phase configuration. The L6 connector does not provide a neutral connection.
The 15 A outlet has a wider earth pin than the 10 A outlet. The 20 A outlet has a wider earth pin and wider Line and Neutral pins. The 25 A outlet has an inverted L-shaped earth pin and wider Line and Neutral pins. The 32 A outlet has a sideways U-shaped earth pin and wider Line and Neutral pins.
The plug is three wire, earthed, rated at 10 A, 250 V and used for Class 1 applications; a slightly larger 16 A version also exists. The nominal pin dimensions of the 10 A version are: 1.5 mm thick by 6.4 mm wide, the line & neutral are 18 mm long, and the earth is 21 mm long. [24] It is similar to the Australian plug.
Yellow NEMA 5-15 extension cord NEMA-1 extension cord, common in the United States Extension cord reel (Germany). An extension cord (US), extension cable, power extender, drop cord, or extension lead (UK) is a length of flexible electrical power cable (flex) with a plug on one end and one or more sockets on the other end (usually of the same type as the plug).
The important socket dimensions which the standard does specify are: A minimum insertion of 9.6 mm from the face of the socket-outlet to the first point of contact with a live part, [67] a minimum distance of 9.5 mm from the line and neutral apertures to the periphery of the socket face, [68] and not to exceed dimensions for the apertures of 7. ...
"Switched socket-outlets and connectors with or without interlock" applies to self-contained products that combine within a single enclosure, a socket-outlet or connector according to IEC 60309-1 or IEC 60309-2 and a switching device, with a rated operating voltage not exceeding 1000 VDC or VAC and 500 Hz, and a rated current not exceeding 800 A.
When modular connectors are used, the latch release of the connector should be on the ridge side of flat phone wire in order to maintain polarity. Though four wires are typically used in U.S. phone cabling, only two are necessary for telecommunication. In the event that a second line is needed, the other two are used.
Ad
related to: dimension line vs extension wire outlet diagram