Ad
related to: ac1200m ap router repeater setup video
Search results
Results from the WOW.Com Content Network
Since only one wireless device can transmit at once, wireless transmissions are doubled (router to the repeater and then repeater to the client versus just router to the client), and so: Wireless throughput is reduced by at least 50%. [1] Wireless interference (e.g., with other networks on the same channel) is at least doubled.
Network 1: A wireless base station acting as a simple (non-WDS) wireless router. The packet leaves the game console, goes over-the-air to the router, which then transmits it across the WAN. One packet comes back, through the router, which transmits it wirelessly to the game console. Total packets sent over-the-air: 2.
802.11 Beacon frame. A beacon frame is a type of management frame in IEEE 802.11 WLANs. It contains information about the network. Beacon frames are transmitted periodically; they serve to announce the presence of a wireless LAN and to provide a timing signal to synchronise communications with the devices using the network (the members of a service set).
In computer networking, a wireless access point (WAP) (also just access point (AP)) is a networking hardware device that allows other Wi-Fi devices to connect to a wired network or wireless network. As a standalone device, the AP may have a wired or wireless connection to a switch or router , but in a wireless router it can also be an integral ...
Router R1 is a one-armed router carrying out inter-VLAN routing. A router on a stick, also known as a one-armed router, [1] [2] is a router that has a single physical or logical connection to a network. It is a method of inter-VLAN routing where one router is connected to a switch via a single cable. The router has physical connections to the ...
Some devices with dual-band wireless network connectivity do not allow the user to select the 2.4 GHz or 5 GHz band (or even a particular radio or SSID) when using Wi-Fi Protected Setup, unless the wireless access point has separate WPS button for each band or radio; however, a number of later wireless routers with multiple frequency bands and ...
Wireless mesh architecture is a first step towards providing cost effective and low mobility over a specific coverage area. Wireless mesh infrastructure is, in effect, a network of routers minus the cabling between nodes. It is built of peer radio devices that do not have to be cabled to a wired port like traditional WLAN access points (AP) do ...
The first SoftAP software was shipped by Ralink with their Wi-Fi cards for Windows XP. It enabled a Wi-Fi card to act as a wireless access point. While a card was acting as a wireless access point, it could not continue to stay connected as a client, so any Internet access had to come from another device, such as an Ethernet device.
Ad
related to: ac1200m ap router repeater setup video