Search results
Results from the WOW.Com Content Network
A solution of 70% ethanol is more effective than pure ethanol because ethanol relies on water molecules for optimal antimicrobial activity. Absolute ethanol may inactivate microbes without destroying them because the alcohol is unable to fully permeate the microbe's membrane.
Methanol and ethanol can both be derived from fossil fuels, biomass, or from carbon dioxide and water. Ethanol has most commonly been produced through fermentation of sugars, and methanol has most commonly been produced from synthesis gas, but there are more modern ways to obtain these fuels. Enzymes can be used instead of fermentation.
If there is more than about 71% ethanol, the remainder can be any proportion of water or gasoline and phase separation does not occur. The fuel mileage declines with increased water content. The increased solubility of water with higher ethanol content permits E30 and hydrated ethanol to be put in the same tank since any combination of them ...
Alcohols are most effective when combined with distilled water to facilitate diffusion through the cell membrane; 100% alcohol typically denatures only external membrane proteins. [25] A mixture of 70% ethanol or isopropanol diluted in water is effective against a wide spectrum of bacteria, though higher concentrations are often needed to ...
Low-ethanol blends are typically from E5 to E25, although internationally the most common use of the term refers to the E10 blend. Blends of E10 or less are used in more than 20 countries around the world, led by the United States, where ethanol represented 10% of the U.S. gasoline fuel supply in 2011. [1]
One car that has higher power on ethanol is the Koenigsegg CCXR, which on ethanol is the fifth-most powerful production car, with 20% more horsepower on E85 than on gasoline. According to the manufacturer, this is due to the cooling properties of ethanol.
The ethanol market share in the U.S. gasoline supply grew by volume from just over 1 percent in 2000 to more than 3 percent in 2006 to 10 percent in 2011. [ 1 ] [ 7 ] [ 8 ] Domestic production capacity increased fifteen times after 1990, from 900 million US gallons to 1.63 billion US gal in 2000, to 13.5 billion US gallons in 2010.
100.0: 100.0: 79.39: 0.79784: 0.78934: 0.78506: 0.78075: 0.79074: 0.78736: −114.3 Mass fraction, % Volume concentration, % Mass concentration, g/(100 ml) at 15.56 °C Density relative to 4 °C water Density at 20 °C relative to 20 °C water Density at 25 °C relative to 25 °C water Freezing temperature, °C 10 °C 20 °C 25 °C 30 °C