Search results
Results from the WOW.Com Content Network
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...
An interrupt vector table (IVT) is a data structure that associates a list of interrupt handlers with a list of interrupt requests in a table of interrupt vectors. Each entry of the interrupt vector table, called an interrupt vector, is the address of an interrupt handler (also known as ISR). While the concept is common across processor ...
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
Upon completion of the service routine, the RTI instruction would be used to return control to the program that made the operating system call. Note that the signature for BRK may be any value, whereas the signature for COP should be limited to the range $00-$7F. [2] The use of BRK and/or COP to request an operating system service means user ...
In computer science, a vectored interrupt is a processing technique in which the interrupting device directs the processor to the appropriate interrupt service routine. This is in contrast to a polled interrupt system, in which a single interrupt service routine must determine the source of the interrupt by checking all potential interrupt ...
A software interrupt is a specific variety of the general concept of an interrupt. An interrupt is a mechanism by which the CPU can be directed to stop executing the main-line program and immediately execute a special program, called an Interrupt Service Routine (ISR), instead. Once the ISR finishes, the CPU continues with the main program.
Hardware interrupts may be mapped to any of the vectors by way of a programmable interrupt controller. On the 80286 and later, the size and locations of the IVT can be changed in the same way as it is done with the IDT (Interrupt descriptor table) in protected mode (i.e., via the LIDT (Load Interrupt Descriptor Table Register) instruction ...
A reentrant interrupt handler is an interrupt handler that re-enables interrupts early in the interrupt handler. This may reduce interrupt latency. [6] In general, while programming interrupt service routines, it is recommended to re-enable interrupts as soon as possible in the interrupt handler. This practice helps to avoid losing interrupts. [7]