Search results
Results from the WOW.Com Content Network
USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions USB 3.0 host controller (xHCI) provides hardware support for streams
Fibre Channel host bus adapter (a 64-bit PCI-X card) [clarification needed] SCSI host adapter (a 16-bit ISA card). In computer hardware a host controller, host adapter or host bus adapter (HBA) connects a computer system bus which acts as the host system to other network and storage devices. [1]
Parallel SCSI (SCSI Parallel Interface SPI) allows for attachment of up to 8 devices (8-bit Narrow SCSI) or 16 devices (16-bit Wide SCSI) to the SCSI bus. The SCSI Host controller takes up one slot on the SCSI bus, which limits the number of devices allowed on the bus to 7 or 15 devices respectively.
The traditional SCSI ID for a host adapter is 7, as that ID has the highest priority during bus arbitration (even on a 16-bit bus). The SCSI ID of a device in a drive enclosure that has a back plane is set either by jumpers or by the slot in the enclosure the device is installed into, depending on the model of the enclosure.
In computing, Serial Attached SCSI (SAS) is a point-to-point serial protocol that moves data to and from computer-storage devices such as hard disk drives, solid-state drives and tape drives. SAS replaces the older Parallel SCSI (Parallel Small Computer System Interface, usually pronounced "scuzzy" [ 3 ] [ 4 ] ) bus technology that first ...
The word nature of data transfer makes the design of a host bus adapter significantly simpler than that of the precursor HDD controller. CTL-I (Controller Interface) [3] was an 8-bit word serial interface introduced by IBM for its mainframe hard disk drives beginning with the 3333 in 1972. [4]
The SCSI command protocols assume that there may be more than one of each device type so they must be each given an 8-bit address. When an SES controller is interrogated for the status of an SES element, the response includes a 4-bit element status code. The most common element status codes are: 1h=OK, 2h=critical, 3h=warning, 5h=not installed.
Open Host Controller Interface (OHCI) [1] is an open standard.. Die shot of a VIA VT6307 Integrated Host Controller used for IEEE 1394A communication. When applied to an IEEE 1394 (also known as FireWire; i.LINK or Lynx) card, OHCI means that the card supports a standard interface to the PC and can be used by the OHCI IEEE 1394 drivers that come with all modern operating systems.