enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. FASTON terminal - Wikipedia

   en.wikipedia.org/wiki/FASTON_terminal

   PLASTI-GRIP (Vinyl) (insulation restricting) terminals are defined in AMP Specification 114-1003: Terminal, FASTON, PLASTI-GRIP, Application of; UL 310 "Standard for Electrical Quick-Connect Terminals" [3] CSA 22.2 #153, "Quick-Connect Terminals" UL 486 also specifies the testing of standard wire connectors and soldering lugs. MIL-T-7928

3. Electric wire ferrule - Wikipedia

   en.wikipedia.org/wiki/Electric_wire_ferrule

   Top: wire terminating in an insulated ferrule Center: Several ferrules with colored insulation, and two uninsulated ferrules Insulated, and uninsulated ferrules. An electric wire ferrule (sometimes electric end terminal) is a metal tube crimped over stranded wire to secure the strands within a screw terminal. Electrical insulation may be ...

4. 110 block - Wikipedia

   en.wikipedia.org/wiki/110_block

   A 110 punch block. A 110 block is a type of punch-down block used to terminate runs of on-premises wiring in a structured cabling system. The designation 110 is also used to describe a type of insulation displacement contact (IDC) connector used to terminate twisted pair cables, [1] which uses a punch-down tool similar to the type used for the older 66 block.

5. List of electronic component packaging types - Wikipedia

   en.wikipedia.org/wiki/List_of_electronic...

   In flip chip systems the IC is connected by solder bumps to a substrate. In beam-lead technology, the metallized pads that would be used for wire bonding connections in a conventional chip are thickened and extended to allow external connections to the circuit. Assemblies using "bare" chips have additional packaging or filling with epoxy to ...

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   A blade connector is a type of single wire, plug-and-socket connection device using a flat conductive blade (plug) that is inserted into a receptacle. Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and uninsulated varieties are available.

7. Solder paste - Wikipedia

   en.wikipedia.org/wiki/Solder_paste

   Solder paste is used in the manufacture of printed circuit boards to connect surface mount components to pads on the board. It is also possible to solder through-hole pin in paste components by printing solder paste in and over the holes. The sticky paste temporarily holds components in place; the board is then heated, melting the paste and ...