enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Glued laminated timber - Wikipedia

    en.wikipedia.org/wiki/Glued_laminated_timber

    Glulam brace with plates used for connections Glulam frame of a roof structure. Glued laminated timber, commonly referred to as glulam, is a type of structural engineered wood product constituted by layers of dimensional lumber bonded together with durable, moisture-resistant structural adhesives so that all of the grain runs parallel to the longitudinal axis.

  3. American historic carpentry - Wikipedia

    en.wikipedia.org/wiki/American_historic_carpentry

    The beams are spaced 4 feet (1.2 m) to 18 feet (5.5 m) apart and the planks are 2 inches (5.1 cm) or more thick possibly with another layer of 1 inch (2.5 cm) on the top as the finished flooring could span these distances. The planks may be laid flat and tongue and grooved or splined together or laid on edge called a laminated floor. [24]

  4. Viga (architecture) - Wikipedia

    en.wikipedia.org/wiki/Viga_(architecture)

    The porch's roof treatment was the same as in the interior room, but the space provided was used for different purposes. Vigas were usually installed with the smaller ends to one side of the roof to facilitate good drainage. [12] Vigas usually sat directly on the adobe or stone walls and were strapped.

  5. Parallel-strand lumber - Wikipedia

    en.wikipedia.org/wiki/Parallel-strand_lumber

    The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...

  6. Flitch beam - Wikipedia

    en.wikipedia.org/wiki/Flitch_beam

    The resulting flitched beam was then secured with resin and bolts, preserving appearance while providing strength. Flitch beams were used as columns in a two-story new construction. Glulam beams were used to support the second floor and the roof. This allowed the appearance of wooden columns, while providing the necessary strength.

  7. Roof pitch - Wikipedia

    en.wikipedia.org/wiki/Roof_pitch

    Historically, roof pitch was designated in two other ways: A ratio of the ridge height to the width of the building (span) [6] and as a ratio of the rafter length to the width of the building. [7] Commonly used roof pitches were given names such as: Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°);

  8. Could changes be coming to Medicare, Medicaid with Dr. Oz ...

    www.aol.com/could-changes-coming-medicare...

    With President-elect Donald Trump's recent announcement of former surgeon-turned-TV host Dr. Mehmet Oz to lead the Centers for Medicare and Medicaid Services (CMS), questions are swirling about ...

  9. Deflection (engineering) - Wikipedia

    en.wikipedia.org/wiki/Deflection_(engineering)

    The deflection at any point, , along the span of a center loaded simply supported beam can be calculated using: [1] = for The special case of elastic deflection at the midpoint C of a beam, loaded at its center, supported by two simple supports is then given by: [ 1 ] δ C = F L 3 48 E I {\displaystyle \delta _{C}={\frac {FL^{3}}{48EI}}} where