Search results
Results from the WOW.Com Content Network
This is a list of firearm cartridges which have bullets in the 11 millimetres (0.43 in) to 11.99 millimetres (0.472 in) caliber range.. Length refers to the cartridge case length
The 45 Raptor (11.5x46mm) is a rimless centerfire cartridge developed for the AR-10 semi-automatic rifle for medium and large game hunting. Compared to similar big bore cartridges designed for the AR-15 – such as the .450 Bushmaster, .458 SOCOM, and .50 Beowulf – the 45 Raptor offers higher velocity bullets, a flatter shooting trajectory and the ability to reliably feed hollow point ...
The smaller "heel" at the base of the bullet was sized to fit inside the brass case at approximately .430 in. [2] Upon firing, the ductile soft lead bullet (alloys of pure to nearly pure lead were used) allowed the base of the bullet to "bump up" to first the chamber diameter in the cylinder, then jump the gap, through the forcing cone into the ...
Case type: Rimmed, bottleneck: Bullet diameter: 11.2 mm (0.44 in) ... 11x58mmR Werndl (upper left) with other contemporary European black powder cartridges. See also
Making of .43 Spanish cartridges in Union Metallic Cartridge Co. factory at Bridgeport, Connecticut, 1877. The .43 Spanish / 11.15x57mmR was a centerfire rifle cartridge developed by Remington designers around 1867. [2]
The .338 Federal is a rifle cartridge based on the .308 Winchester case necked up to .33 caliber. It was created by Federal Cartridge and Sako in 2006 and intended as a big-game cartridge with reasonable recoil for lightweight rifles. [3].338 Federal can use SR-25 pattern magazines but requires to further modification [4]
A two-piece 11mm cartridge (left) compared to a more modern 7.65×53mm Mauser. The 11mm Mauser (also known as the 11×60mmR Mauser or .43 Mauser) is a black-powder cartridge developed for the Mauser Model 1871 rifle, and used later in the 71/84 variant.
Rack units are typically denoted without a space between the number of units and the 'U'. Thus, a 4U server enclosure (case) is seven inches (177.8 mm) high, or more practically, built to occupy a vertical space seven inches high, with sufficient clearance to allow movement of adjacent hardware.