Search results
Results from the WOW.Com Content Network
The chirp pulse compression process transforms a long duration frequency-coded pulse into a narrow pulse of greatly increased amplitude. It is a technique used in radar and sonar systems because it is a method whereby a narrow pulse with high peak power can be derived from a long duration pulse with low peak power.
Typically, these fences are 2.4 metres (7 ft 10 in) tall and send high voltage electric pulses through the palisade at a frequency of 1 Hz (one pulse per second). Palisade electric fences are used in most countries, particularly where there is little vegetation to short-circuit the fence or where the costs of security personnel are high in ...
The pulse-repetition frequency (PRF) is the number of pulses of a repeating signal in a specific time unit. The term is used within a number of technical disciplines, notably radar . In radar, a radio signal of a particular carrier frequency is turned on and off; the term "frequency" refers to the carrier, while the PRF refers to the number of ...
The amount of energy that is returned to the radar receiver is a function of the peak energy of the pulse, the pulse width, and the pulse repetition frequency. Increasing the pulse width increases the amount of energy reflected off the target and thereby increases the range at which an object can be detected. Radars measure range based on the ...
Data analysis showed a pulse repetition interval (PRI) of about 90 ms, a frequency range of 7 to 19 MHz, a bandwidth of 0.02 to 0.8 MHz, and typical transmission time of 7 minutes. The pulses transmitted by the Woodpecker had a wide bandwidth, typically 40 kHz.
The transponder receives coded or single pulse interrogation from ground stations and transmits a single-pulse reply in the same frequency band. A common antenna is used for receiving and transmitting. The transponder consists of five functional systems: superheterodyne receiver, decoder, modulator, transmitter, and power supply.
Plot of normalized function (i.e. ()) with its spectral frequency components.. The unitary Fourier transforms of the rectangular function are [2] = = (), using ordinary frequency f, where is the normalized form [10] of the sinc function and = (/) / = (/), using angular frequency , where is the unnormalized form of the sinc function.
The two coincide in fact in NRZ transmission; they do not coincide in a 2B1Q transmission, where one pulse takes the time of two bits. For example, in a serial line with a baud rate of 2.5 Gbit/s, a unit interval is 1/(2.5 Gbit/s) = 0.4 ns/baud.