Search results
Results from the WOW.Com Content Network
This mode is similar to the XOR mode above and supports the same balancing policies. The link is set up dynamically between two LACP-supporting peers. Adaptive transmit load balancing (balance-tlb) Linux bonding driver mode that does not require any special network-switch support.
Pairing, sometimes known as bonding, is a process used in computer networking that helps set up an initial linkage between computing devices to allow communications between them. The most common example is used in Bluetooth , [ 1 ] where the pairing process is used to link devices like a Bluetooth headset with a mobile phone .
The "pairing" of Wi-Fi Direct devices can be set up to require the proximity of a near field communication, a Bluetooth signal, or a button press on one or all the devices. Simultaneous connections also allow one device connected via an infrastructure local area network to the Internet to share the Internet connection to devices it is connected ...
This allows computers to have dedicated bandwidth on point-to-point connections to the network and also to run in full-duplex mode. Full-duplex mode has only one transmitter and one receiver per collision domain, making collisions impossible. The network switch plays an integral role in most modern Ethernet local area networks (LANs). Mid-to ...
Switch mode, switched mode or switching mode may refer to: Switch-mode amplifier; Switch-mode converter; Switch-mode power supply; Switch-mode regulator; See also.
An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers) or two switches to each other.
Alternately, a PIN provided by the access point may be entered into the new device. This method is the mandatory baseline mode and everything must support it. The Wi-Fi Direct specification supersedes this requirement by stating that all devices with a keypad or display must support the PIN method. [6] Push button method
Because the switch only ever buffers 64 bytes of each frame, fragment-free is a faster mode than store-and-forward, but there still exists a risk of forwarding bad frames. [7] There are certain scenarios that force a cut-through Ethernet switch to buffer the entire frame, acting like a store-and-forward Ethernet switch for that frame: