enow.com Web Search

  1. Ads

    related to: 2 foot diameter drainage pipe prices

Search results

  1. Results from the WOW.Com Content Network
  2. Fixture unit - Wikipedia

    en.wikipedia.org/wiki/Fixture_unit

    A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...

  3. Effluent sewer - Wikipedia

    en.wikipedia.org/wiki/Effluent_sewer

    Effluent pumping systems have pipes that are buried at a constant depth, such as a metre and a half, and rely on pumping stations that create pressure to move the waste to a treatment facility. An effluent sewer that uses gravity may be called a septic tank effluent gravity (STEG) system, while a pumping system may be called a septic tank ...

  4. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    All DWV systems require various sized fittings and pipes which are measured by their internal diameter of both the pipes and the fittings which, and in most cases are Schedule 40 PVC wye's, tee's, elbows ranging from 90 degrees to 22.5 degrees for both inside diameter fitment (street) as well as outer diameter fitment (hub), repair and slip ...

  5. Combined sewer - Wikipedia

    en.wikipedia.org/wiki/Combined_sewer

    The planned cost for the project will total $1.9 billion. [27] Fort Wayne, Indiana, is constructing a 4.5-mile (7.2 km), 14-foot (4.3 m) diameter, $180M tunnel under the 3RPORT [28] (Three Rivers Protection and Overflow Reduction Tunnel) to address the myriad CSOs which outfall into the St. Mary's, St. Joseph, and Maumee Rivers. The 3RPORT is ...

  6. Trench drain - Wikipedia

    en.wikipedia.org/wiki/Trench_drain

    The drain is characterized by its long length and narrow width, the cross-section of the drain is a function of the maximum flow volume anticipated from the surrounding surface. Channels can range from 1 inch (2.5 cm) to 2 feet (61 cm) in width, while depths can reach up to 4 feet (120 cm).

  7. Plumbing - Wikipedia

    en.wikipedia.org/wiki/Plumbing

    [28] 1/2" L copper has the same outer diameter as 1/2" K or M copper. The same applies to pipe schedules. As a result, a slight increase in pressure losses is realized due to a decrease in flowpath as wall thickness is increased. In other words, 1 foot of 1/2" L copper has slightly less volume than 1 foot of 1/2 M copper. [29]

  1. Ads

    related to: 2 foot diameter drainage pipe prices