enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 19-inch rack - Wikipedia

   en.wikipedia.org/wiki/19-inch_rack

   The size denotes the width of the faceplate for the installed equipment. The rack unit is a measure of vertical spacing and is common to both the 19 and 23-inch racks. Hole spacing is either on 1-inch (25 mm) centers (Western Electric standard), or the same as for 19-inch (482.6 mm) racks (0.625 in or 15.9 mm spacing).

3. Rack unit - Wikipedia

   en.wikipedia.org/wiki/Rack_unit

   Rack with sample component sizes including an A/V half-rack unit. A rack unit (abbreviated U or RU) is a unit of measure defined as 1 + 3 ⁄ 4 inches (44.45 mm). [1] [2] It is most frequently used as a measurement of the overall height of 19-inch and 23-inch rack frames, as well as the height of equipment that mounts in these frames, whereby the height of the frame or equipment is expressed ...

4. 32 mm cabinetmaking system - Wikipedia

   en.wikipedia.org/wiki/32_mm_cabinetmaking_system

   In addition to the 32 mm standard, there are other but less frequently used systems (System 25, ip20 etc.). [ 1 ] [ 2 ] [ 3 ] The system allows reconfigurable shelf placement and spacing. The system was developed by fitting, machine and furniture manufacturers, and serves to standardize both component dimensions and production processes.

5. Filing cabinet - Wikipedia

   en.wikipedia.org/wiki/Filing_cabinet

   Lateral files are typically 20 inches (510 mm) deep and manufactured in 30,-36,-and-42-inch (760, 910, and 1,070 mm) widths and 2-, 3-, 4-, and 5-drawer versions. The 30-inch-wide (760 mm), two-drawer version is popular for use inside cubicle workstations, as it is engineered to fit under or alongside the cubicle work surfaces.

6. List of disk drive form factors - Wikipedia

   en.wikipedia.org/wiki/List_of_disk_drive_form...

   4 in × 1 in × 5.75 in (101.6 mm × 25.4 mm × 146 mm) = 376.77344 cm³. This smaller form factor is similar to that used in an HDD by Rodime in 1983, which was the same size as the "half height" 3½" FDD, i.e., 1.63 inches high. Today, the 1-inch high ("slimline" or "low-profile") version of this form factor is the most popular form used in ...

7. Eurocard (printed circuit board) - Wikipedia

   en.wikipedia.org/wiki/Eurocard_(printed_circuit...

   Two common heights are 3U (a 100 mm card in a 5.25 in (133.35 mm) subrack) and 6U (a 233.35 mm card in a 10.5 in (266.70 mm) high subrack). As two 3U cards are shorter than a 6U card (by 33.35 mm), it is possible to install two 3U cards in one slot of a 6U subrack, with a mid-height structure for proper support.