Search results
Results from the WOW.Com Content Network
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.
In computing, an input–output memory management unit (IOMMU) is a memory management unit (MMU) connecting a direct-memory-access–capable (DMA-capable) I/O bus to the main memory. Like a traditional MMU, which translates CPU -visible virtual addresses to physical addresses , the IOMMU maps device-visible virtual addresses (also called device ...
The simplest system bus has completely separate input data lines, output data lines, and address lines. To reduce cost, most microcomputers have a bidirectional data bus, re-using the same wires for input and output at different times. [20] Some processors use a dedicated wire for each bit of the address bus, data bus, and the control bus.
Each device can request up to six areas of memory space or input/output (I/O) port space via its configuration space registers. In a typical system, the firmware (or operating system ) queries all PCI buses at startup time (via PCI Configuration Space ) to find out what devices are present and what system resources (memory space, I/O space ...
Devices for communication between computers, such as modems and network cards, typically perform both input and output operations. Any interaction with the system by an interactor is an input and the reaction the system responds is called the output. The designation of a device as either input or output depends on perspective.
Input and output voltages are usually, but not always, limited to the supply voltage of the device with the GPIOs, and may be damaged by greater voltages. A GPIO pin's state may be exposed to the software developer through one of a number of different interfaces, such as a memory-mapped I/O peripheral, or through dedicated IO port instructions ...
To prevent bus contention on the data bus, at any one instant only one device drives the data bus. In very simple systems, only the data bus is required to be a bidirectional bus. In very simple systems, the memory address register always drives the address bus, the control unit always drives the control bus, and an address decoder selects ...
Programmed input–output (also programmable input/output, programmed input/output, programmed I/O, PIO) is a method of data transmission, via input/output (I/O), between a central processing unit (CPU) and a peripheral device, [1] such as a Parallel ATA storage device. Each data item transfer is initiated by an instruction in the program ...