Search results
Results from the WOW.Com Content Network
-f: Clears the routing table-p: The route is added to the Windows Registry and is used to initialize the IP routing table whenever the TCP/IP protocol is started (only when used with the add command) Command: The command to run (add, change, delete, print)-4: Force using IPv4-6: Force using IPv6; Destination: Network destination of the route
Explicit Congestion Notification (ECN) is an extension to the Internet Protocol and to the Transmission Control Protocol and is defined in RFC 3168 (2001). ECN allows end-to-end notification of network congestion without dropping packets.
The Neighbor Discovery Protocol (NDP), or simply Neighbor Discovery (ND), is a protocol of the Internet protocol suite used with Internet Protocol Version 6 (IPv6). [1]: §1 It operates at the internet layer of the Internet model, [2] and is responsible for gathering various information required for network communication, including the configuration of local connections and the domain name ...
The ICMP Router Advertisement message is sent by a router on the local area network to announce its IP address as available for routing. When a host boots up, it sends solicitation messages to IP multicast address 224.0.0.2. [4] In response, one or more routers may send advertisement messages.
A routing protocol shares this information first among immediate neighbors, and then throughout the network. This way, routers gain knowledge of the topology of the network . The ability of routing protocols to dynamically adjust to changing conditions such as disabled connections and components and route data around obstructions is what gives ...
eth0 is the interface name of the network interface card representing an Ethernet port. ppp0 is a PPPoE interface, which is configured as the default route in this example. A default route is recognized by the destination 0.0.0.0 and the flag G. A network router is identified by the network mask 255.255.255.255 and the flag H.
In computing, netsh, or network shell, is a command-line utility included in Microsoft's Windows NT line of operating systems beginning with Windows 2000. [1] It allows local or remote configuration of network devices such as the interface .
Loose Source Routing is an IP option which can be used for address translation. LSR is also used to implement mobility in IP networks. [3] Loose source routing uses a source routing option in IP to record the set of routers a packet must visit. The destination of the packet is replaced with the next router the packet must visit.