enow.com Web Search

  1. Ads

    related to: heat transfer procedure led replacement tubes for t12 lamp

Search results

  1. Results from the WOW.Com Content Network
  2. Thermal management of high-power LEDs - Wikipedia

    en.wikipedia.org/wiki/Thermal_management_of_high...

    Heat sinks provide a path for heat from the LED source to outside medium. Heat sinks can dissipate power in three ways: conduction (heat transfer from one solid to another), convection (heat transfer from a solid to a moving fluid, which for most LED applications will be air), or radiation (heat transfer from two bodies of different surface temperatures through Thermal radiation).

  3. LED tube - Wikipedia

    en.wikipedia.org/wiki/LED_tube

    LED tubes. LED tube is a type of LED lamp used in fluorescent tube luminaires with G5 and G13 bases to replace traditional fluorescent tubes. [1] As compared to fluorescent tubes, the most important advantages of LED tubes are energy efficiency and long service life. LED tubes are sometimes also referred to as ‘LED fluorescent tubes’.

  4. Fluorescent-lamp formats - Wikipedia

    en.wikipedia.org/wiki/Fluorescent-lamp_formats

    High-lumen retrofit lamps for 40W T12 lamps in North America. Popular tube diameter in Japan; Circular 32W and 40W T10 lamps (Older versions of the 32W and 40W T9 lamps) T12 T38 1 + 1 ⁄ 2: 38.1 G13 bi-pin; Fa8 single-pin; R17d recessed double contact; One of the first diameters of fluorescent lamps, with the 15W T12 and 20W T12 having been ...

  5. Fluorescent lamp - Wikipedia

    en.wikipedia.org/wiki/Fluorescent_lamp

    A fluorescent lamp tube is filled with a mix of argon, xenon, neon, or krypton, and mercury vapor. The pressure inside the lamp is around 0.3% of atmospheric pressure. [27] The partial pressure of the mercury vapor alone is about 0.8 Pa (8 millionths of atmospheric pressure), in a T12 40-watt lamp. [28]

  6. LED lamp - Wikipedia

    en.wikipedia.org/wiki/LED_lamp

    A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

  7. Electrical ballast - Wikipedia

    en.wikipedia.org/wiki/Electrical_ballast

    The ballast in such systems can equally be a resistor. A number of fluorescent lamp fittings used a filament lamp as the ballast in the late 1950s through to the 1960s. Special lamps were manufactured that were rated at 170 volts and 120 watts. The lamp had a thermal starter built into the 4 pin base.

  1. Ads

    related to: heat transfer procedure led replacement tubes for t12 lamp