enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Even on many drill presses, handheld drills, and lathes, which have chucks (such as a drill chuck or collet chuck), the chuck is attached by a taper. On drills, drill presses, and milling machines , the male member is the tool shank or toolholder shank, and the female socket is integral with the spindle.

3. Drill - Wikipedia

   en.wikipedia.org/wiki/Drill

   A geared head drill press, with up to eight possible speeds accessible via shift levers on the head and a two speed motor control immediately in front of the quill handle. A geared head drill press transmits power from the motor to the spindle through spur gearing inside the machine's head, eliminating a flexible drive belt. This assures a ...

4. Gimlet (tool) - Wikipedia

   en.wikipedia.org/wiki/Gimlet_(tool)

   It was defined in Joseph Gwilt's Architecture (1859) as "a piece of steel of a semi-cylindrical form, hollow on one side, having a cross handle at one end and a worm or screw at the other". [1] A gimlet is always a small tool. A similar tool of larger size is called an auger. The cutting action of the gimlet is slightly different from an auger ...

5. Spindle (tool) - Wikipedia

   en.wikipedia.org/wiki/Spindle_(tool)

   In machine tools, a spindle is a rotating axis of the machine, which often has a shaft at its heart. The shaft itself is called a spindle, but also, in shop-floor practice, the word often is used metonymically to refer to the entire rotary unit, including not only the shaft itself, but its bearings and anything attached to it (chuck, etc.).

6. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.

7. Indexing head - Wikipedia

   en.wikipedia.org/wiki/Indexing_head

   Indexing heads are usually used on the tables of milling machines, but may be used on many other machine tools including drill presses, grinders, and boring machines. Common jobs for a dividing head include machining the flutes of a milling cutter , cutting the teeth of a gear , milling curved slots, or drilling a bolt hole circle around the ...