Search results
Results from the WOW.Com Content Network
English: Detail of a steel truss, like it is build nowadays, it uses welds and bolds due to the fact it is at site joint, where two parts get connected at site (see Plan of the tuss). It is a part of a Plan (File:Det JoKa008-Model.pdf), which shows three details of a truss (File:Fachwerkplan.pdf)
The staggered truss system is a type of structural steel framing used in high-rise buildings. The system consists of a series of story-high trusses spanning the total width between two rows of exterior columns and arranged in a staggered pattern on adjacent column lines. [ 1 ]
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
Truss bridge for a single-track railway, converted to pedestrian use and pipeline support. In this example the truss is a group of triangular units supporting the bridge. Typical detail of a steel truss, which is considered as a revolute joint Historical detail of a steel truss with an actual revolute joint
Door –: A post framing a doorway. Blade – A specific name for the post-like timber in cruck framing. Cruck stud – The upright stud or post forming a wall, mounted on a cruck blade and held by a cruck spur. Pile, piling – A post driven or set into the ground such as in earthfast, post in ground, or "posthole construction". [16]
The main function of an OWSJ is to provide direct support for roof or floor deck and to transfer the load imposed on the deck to the structural frame i.e. beam and column. In order to accurately design an OWSJ, engineers consider the joist span between bearing points, joist spacing, slope, live loads , dead loads , collateral loads, seismic ...
Channel or C section girts bolted to plate cleats welded to a portal column in an industrial building. In architecture or structural engineering, a girt, also known as a sheeting rail, is a horizontal structural member in a framed wall. Girts provide lateral support to the wall panel, primarily to resist wind loads. [citation needed]
The king post is the central, vertical member of the truss. Crown posts in the nave roof at Old Romney church, Kent, England. A king post (or king-post or kingpost) is a central vertical post used in architectural or bridge designs, working in tension to support a beam below from a truss apex above (whereas a crown post, though visually similar, supports items above from the beam below).