enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Telephone jack and plug - Wikipedia

   en.wikipedia.org/wiki/Telephone_jack_and_plug

   For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...

3. Registered jack - Wikipedia

   en.wikipedia.org/wiki/Registered_jack

   A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a patch panel with one spare pair. Alternatively, only the necessary pairs for 10/100 Ethernet can be wired allowing twelve Ethernet ports with a single spare pair. This connector is also used with spring bail locks for SCSI-1 connections.

4. Category 5 cable - Wikipedia

   en.wikipedia.org/wiki/Category_5_cable

   Category 5 cable is nearly always terminated with 8P8C modular connectors (often referred to incorrectly as RJ45 connectors [14] [15] [16]). The cable is terminated in either the T568A scheme or the T568B scheme. The two schemes work equally well and may be mixed in an installation so long as the same scheme is used on both ends of each cable.

5. ANSI/TIA-568 - Wikipedia

   en.wikipedia.org/wiki/ANSI/TIA-568

   The standard specifies how to connect eight-conductor 100-ohm balanced twisted-pair cabling, such as Category 5 cable, to 8P8C modular connectors (often referred to as RJ45 connectors). The standard defines two alternative pinouts: T568A and T568B. ANSI/TIA-568 recommends the T568A pinout for horizontal cables.

6. Keystone module - Wikipedia

   en.wikipedia.org/wiki/Keystone_module

   Some keystones use a pass-through type connector, where there is a jack on both the front face and the rear side. Others only have a jack on the front and employ a different mechanism for hard-wiring signal cables to the rear, such as a mini 110 block , an insulation-displacement connector , or a crimp or solder connection.

7. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   The first types of small modular telephone connectors were created by AT&T in the mid-1960s for the plug-in handset and line cords of the Trimline telephone. [1] Driven by demand for multiple sets in residences with various lengths of cords, the Bell System introduced customer-connectable part kits and telephones, sold through PhoneCenter stores in the early 1970s. [2]

8. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   In some instances USB through version 2 on motherboards – 2.54 mm pitch, 10 pins, 2×5 (2 rows of 5 pins) [9] For all of the above connectors, the computer manufacturer typically attaches a female IDC connector onto one end of a ribbon cable, and later slides that connector onto a matching male box header or pin header on the computer ...

9. FASTON terminal - Wikipedia

   en.wikipedia.org/wiki/FASTON_terminal

   Insulated versions of the terminals are color-coded to indicate what wire gauges they may be used with. The terminal system consists of tabs (male) and receptacles (female). There are free-hanging wire and circuit board mounted versions of both tabs and receptacles. All widths come mostly in one of two tab thicknesses: 0.032 and 0.020 in (0.8 ...