Search results
Results from the WOW.Com Content Network
In this convention, one thousand and twenty-four megabytes (1024 MB) is equal to one gigabyte (1 GB), where 1 GB is 1024 3 bytes (i.e., 1 GiB). Mixed 1 MB = 1 024 000 bytes (= 1000×1024 B) is the definition used to describe the formatted capacity of the 1.44 MB 3.5-inch HD floppy disk, which actually has a capacity of 1 474 560 bytes. [5]
In order to calculate the data transmission rate, one must multiply the transfer rate by the information channel width. For example, a data bus eight-bytes wide (64 bits) by definition transfers eight bytes in each transfer operation; at a transfer rate of 1 GT/s, the data rate would be 8 × 10 9 B/s, i.e. 8 GB/s, or approximately 7.45 GiB/s
The naming convention for DDR, DDR2 and DDR3 modules specifies either a maximum speed (e.g., DDR2-800) or a maximum bandwidth (e.g., PC2-6400). The speed rating (800) is not the maximum clock speed, but twice that (because of the doubled data rate). The specified bandwidth (6400) is the maximum megabytes transferred per second using a 64-bit width.
Same build as SD but greater capacity and transfer speed, 4 GB to 32 GB (not compatible with older host devices). miniSDHC: 2008 32 GB [4] Same build as miniSD but greater capacity and transfer speed, 4 GB to 32 GB. 8 GB is largest in early-2011 (not compatible with older host devices). microSDHC: 2007 32 GB [4]
An alternative system of nomenclature for the same units (referred to here as the customary convention), in which 1 kilobyte (KB) is equal to 1,024 bytes, [38] [39] [40] 1 megabyte (MB) is equal to 1024 2 bytes and 1 gigabyte (GB) is equal to 1024 3 bytes is mentioned by a 1990s JEDEC standard. Only the first three multiples (up to GB) are ...
The Intel 8088 CPU, used in the original IBM PC, was able to address 1 MB (2 20 bytes), since the chip offered 20 address lines. In the design of the PC, the memory below 640 KB was for random-access memory on the motherboard or on expansion boards, and it was called the conventional memory area.
Those modules are identified by an additional R in their designation, whereas non-registered (a.k.a. "unbuffered") RAM may be identified by an additional U in the designation. PC2-4200R is a registered PC2-4200 module, PC2-4200R ECC is the same module but with additional ECC.
While the gross data rate equals 33.3 million 4-bit-transfers per second (or 16.67 MB/s), the fastest transfer, firmware read, results in 15.63 MB/s. The next fastest bus cycle, 32-bit ISA-style DMA write, yields only 6.67 MB/s .