enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Agate (typography) - Wikipedia

    en.wikipedia.org/wiki/Agate_(typography)

    An agate or ruby is a unit of typographical measure. It is 5.5 typographical points, or about 1 ⁄ 13 inch (1.94 mm). It can refer either to the height of a line of type or to a font that is 5.5 points. An agate font is commonly used to display statistical data or legal notices in newspapers.

  3. Typographic unit - Wikipedia

    en.wikipedia.org/wiki/Typographic_unit

    The traditional typographic units are based either on non-metric units, or on odd multiples (such as 35 ⁄ 83) of a metric unit.There are no specifically metric units for this particular purpose, although there is a DIN standard sometimes used in German publishing, which measures type sizes in multiples of 0.25 mm, and proponents of the metrication of typography generally recommend the use of ...

  4. Rack unit - Wikipedia

    en.wikipedia.org/wiki/Rack_unit

    Rack with sample component sizes including an A/V half-rack unit. A rack unit (abbreviated U or RU) is a unit of measure defined as 1 + 3 ⁄ 4 inches (44.45 mm). [1] [2] It is most frequently used as a measurement of the overall height of 19-inch and 23-inch rack frames, as well as the height of equipment that mounts in these frames, whereby the height of the frame or equipment is expressed ...

  5. Point (typography) - Wikipedia

    en.wikipedia.org/wiki/Point_(typography)

    He did not change the subdivisions (1 inch = 12 subdivisions = 72 points), but defined it strictly in terms of the royal foot, a legal length measure in France: the Didot point is exactly 1 ⁄ 864 of a French foot or 1 ⁄ 72 of a French inch, that is (by 1799) 15 625 ⁄ 41 559 mm or about 0.375 972 mm. Accordingly, one Didot point is exactly ...

  6. Delay calculation - Wikipedia

    en.wikipedia.org/wiki/Delay_calculation

    Similarly, there are many ways to calculate the delay of a wire. The delay of a wire will normally be different for each destination. In order to increase accuracy (and decrease speed), the most common methods are: Lumped C. The entire wire capacitance is applied to the gate output, and the delay through the wire itself is ignored.

  7. Saints QB Derek Carr leaves win over Giants early with hand ...

    www.aol.com/sports/saints-qb-derek-carr-leaves...

    The Saints now hold a 5-8 record with the win, which marked their third in their past four games. Lock went 21 of 49 for 227 yards with an interception for the Giants, who dropped to 2-11 with the ...

  8. Gate equivalent - Wikipedia

    en.wikipedia.org/wiki/Gate_equivalent

    A gate equivalent (GE) stands for a unit of measure which allows specifying manufacturing-technology-independent complexity of digital electronic circuits. For today's CMOS technologies, the silicon area of a two-input drive-strength-one NAND gate usually constitutes the technology-dependent unit area commonly referred to as gate equivalent.

  9. Gang-tied illegal immigrant ‘giggled’ as he confessed to ...

    www.aol.com/gang-tied-illegal-immigrant-giggled...

    A gang member “giggled” as he admitted to kidnapping a young Texas woman at gunpoint and threatening to pimp her out and sell her organs, according to cops.