Search results
Results from the WOW.Com Content Network
There are several types of Ethernet frames: Ethernet II frame, or Ethernet Version 2, [g] or DIX frame is the most common type in use today, as it is often used directly by the Internet Protocol. Novell raw IEEE 802.3 non-standard variation frame; IEEE 802.2 Logical Link Control (LLC) frame; IEEE 802.2 Subnetwork Access Protocol (SNAP) frame
Through the first half of the 1980s, Ethernet's 10BASE5 implementation used a coaxial cable 0.375 inches (9.5 mm) in diameter, later called thick Ethernet or thicknet. Its successor, 10BASE2, called thin Ethernet or thinnet, used the RG-58 coaxial cable. The emphasis was on making installation of the cable easier and less costly.
A frame is a series of bits generally composed of frame synchronization bits, the packet payload, and a frame check sequence. Examples are Ethernet frames, Point-to-Point Protocol (PPP) frames, Fibre Channel frames, and V.42 modem frames. Often, frames of several different sizes are nested inside each other.
EtherType is a two-octet field in an Ethernet frame. It is used to indicate which protocol is encapsulated in the payload of the frame and is used at the receiving end by the data link layer to determine how the payload is processed. The same field is also used to indicate the size of some Ethernet frames.
This page was last edited on 11 September 2020, at 03:05 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
Jumbo frames have payloads greater than 1500 bytes. In computer networking, jumbo frames are Ethernet frames with more than 1500 bytes of payload, the limit set by the IEEE 802.3 standard. [1] The payload limit for jumbo frames is variable: while 9000 bytes is the most commonly used limit, smaller and larger limits exist.
Insertion of 802.1ad tag in Ethernet-II frame. These examples are for an Ethernet II framing with EtherType field. The standard is also applicable to IEEE 802.3 frames with or without an LLC (i.e. Logical Link Control), LLC+SNAP header). The top frame is a simple Ethernet II frame. The middle frame has an 802.1Q tag added to it. The bottom ...
A data unit at layer 2, the data link layer, is a frame. In layer 4, the transport layer, the data units are segments and datagrams. Thus, in the example of TCP/IP communication over Ethernet, a TCP segment is carried in one or more IP packets, which are each carried in one or more Ethernet frames.