Search results
Results from the WOW.Com Content Network
Lift-off oversteer (also known as trailing-throttle oversteer, throttle off oversteer, or lift-throttle oversteer) is a form of sudden oversteer.While cornering, a driver who closes the throttle (by lifting a foot off the accelerator, hence the name), usually at a high speed, can cause such sudden deceleration that the vertical load on the tires shifts from rear to front, in a process called ...
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
The actuator consists of a linear servo actuator servomotor that controls a plunger which varies air flow through the throttle body. The position of the servomotor and hence the amount of air bypass is controlled digitally by the engine ECU. This allows the engine's idle speed to be maintained constant.
2000: Several Ford Explorers were reported in the UK where the vehicle was already moving and experienced sudden acceleration. [26] 2004: The NHTSA sent Toyota a chart showing that Toyota Camry models with electronic throttle controls had over 400% more "vehicle speed" complaints than those with manual controls. [citation needed]
Developed to help the driver maintain the intended line through a corner; an onboard computer monitored several vehicle operating parameters through various sensors. When too much throttle had been used when taking a curve, engine output and braking were automatically regulated to ensure the proper line through a curve and to provide the proper ...
The closed throttle provides engine braking by forcing the engine to generate a vacuum between the throttle and the cylinders. Typically, the controls for a compression brake consist of an on/off switch and often a selector that controls the number of cylinders on which the brake is active. Throttle and clutch switches are integral with the system.