Search results
Results from the WOW.Com Content Network
A switch virtual interface (SVI) represents a logical layer-3 interface on a switch. VLANs divide broadcast domains in a LAN environment. Whenever hosts in one VLAN need to communicate with hosts in another VLAN, the traffic must be routed between them. This is known as inter-VLAN routing.
SCPI commands to an instrument may either perform a set operation (e.g. switching a power supply on) or a query operation (e.g. reading a voltage). Queries are issued to an instrument by appending a question-mark to the end of a command. Some commands can be used for both setting and querying an instrument.
NCQ—Native Command Queuing; NCSA—National Center for Supercomputing Applications; NDIS—Network Driver Interface Specification; NDPS—Novell Distributed Print Services; NDS—Novell Directory Services; NEP—Network Equipment Provider; NetBIOS—Network Basic Input/Output System; NetBT—NetBIOS over TCP/IP; NEXT—Near-End CrossTalk
Cases where this setup is used can be found in servers dedicated for prints, files or for segmenting different departments. An example of router on a stick usage is found in Call Manager Express installation, when the Voice over IP network and Cisco IP phone devices have a need to split. [3]
In IP-based computer networks, virtual routing and forwarding (VRF) is a technology that allows multiple instances of a routing table to co-exist within the same router at the same time.
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts.
Sludge Volume Index (SVI) is a process control parameter used to describe the settling characteristics of sludge in the aeration tank of an activated sludge process. [1] It was introduced by Mohlman in 1934 and has become one of the standard measures of the physical characteristics of activated sludge processes.
Instruction class - indicates the type of command, e.g., interindustry or proprietary INS 1 Instruction code - indicates the specific command, e.g., "select", "write data" P1-P2 2 Instruction parameters for the command, e.g., offset into file at which to write the data L c: 0, 1 or 3 Encodes the number (N c) of bytes of command data to follow