Search results
Results from the WOW.Com Content Network
dhcpd (an abbreviation for "DHCP daemon") was a DHCP server program that operates as a daemon on a server to provide Dynamic Host Configuration Protocol (DHCP) service to a network. [3] This implementation, also known as ISC DHCP, is one of the first and best known, but there are now a number of other DHCP server software implementations available.
The Dynamic Host Configuration Protocol (DHCP) is a network management protocol used on Internet Protocol (IP) networks for automatically assigning IP addresses and other communication parameters to devices connected to the network using a client–server architecture.
In this overview of operating system support for the discussed DHCP server, the following terms indicate the level of support: No indicates that it does not exist or was never released. Yes indicates that it has been officially released in a fully functional, stable version.
Kea is an open-source DHCP server developed by the Internet Systems Consortium, authors of ISC DHCP, also known as DHCPd.Kea and ISC DHCP are both implementations of the Dynamic Host Configuration Protocol, a set of standards established by the Internet Engineering Task Force (IETF).
GNU/*/Linux (or Owl for short) is a small security-enhanced Linux distribution for servers, appliances, and virtual appliances. Effectively at end of life. OpenWrt: Active: Linux: x86, x86-64, MIPS, ARM, PowerPC, AVR32, CRIS, m68k, SPARC, SuperH, Ubicom32, etc. GPL V2: Free: Linux distribution with a focus on CPE-routers and
ConnMan is an internet connection manager for embedded devices running the Linux operating system. The Connection Manager is designed to be slim and to use as few resources as possible, so it can be easily integrated. It is a fully modular system that can be extended, through plug-ins, to support all kinds of wired or wireless technologies.
The Internet Engineering Task Force (IETF) has reserved the IPv4 address block 169.254.0.0 / 16 (169.254.0.0 – 169.254.255.255) for link-local addressing. [1] The entire range may be used for this purpose, except for the first 256 and last 256 addresses (169.254.0.0 / 24 and 169.254.255.0 / 24), which are reserved for future use and must not be selected by a host using this dynamic ...
On Linux and all Unix-like operating systems, the utilities ifconfig and the newer ip (from the iproute2-bundle) are used to configure IEEE 802.3 and IEEE 802.11 hardware. These utilities configure the kernel directly and the configuration is applied immediately. After boot-up, the user is required to configure them again.