enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Battery charger - Wikipedia

   en.wikipedia.org/wiki/Battery_charger

   Inductive battery chargers use electromagnetic induction to charge batteries. A charging station sends electromagnetic energy through inductive coupling to an electrical device, which stores the energy in the batteries. This is achieved without the need for metal contacts between the charger and the battery.

3. Soldering station - Wikipedia

   en.wikipedia.org/wiki/Soldering_station

   A soldering station is a multipurpose power soldering device designed for electronic components soldering. This type of equipment is mostly used in electronics and electrical engineering . Soldering station consists of one or more soldering tools connected to the main unit, which includes the controls (temperature adjustment), means of ...

4. Float voltage - Wikipedia

   en.wikipedia.org/wiki/Float_voltage

   Float voltage is the voltage at which a battery is maintained after being fully charged to maintain that capacity by compensating for self-discharge of the battery. [1] The voltage could be held constant for the entire duration of the cell's operation (such as in an automotive battery) or could be held for a particular phase of charging by the charger. [2]

5. DC connector - Wikipedia

   en.wikipedia.org/wiki/DC_connector

   Although the nominal voltage of a 12 V lead acid battery is 12 V DC, when the engine is running the car's battery charging system will bring the system voltage to 13.8 V DC or higher. [10] The possible range of battery voltages from 11–15 V DC must be taken into account by devices attached to the cigar lighter socket.

6. IUoU battery charging - Wikipedia

   en.wikipedia.org/wiki/IUoU_battery_charging

   Example charging graph. On the left: per-cell quantities. On the right: example values for a 40 Ah, 6-cell (12 V) battery. Note: schematic illustration; not based on actual measurements. IUoU is a DIN-designation [1] (DIN 41773) for a lead-acid battery charging procedure that is also known as 3-stage charging, 3-phase charging, or 3-step charging.

7. Charge controller - Wikipedia

   en.wikipedia.org/wiki/Charge_controller

   A shunt charge controller or shunt regulator diverts excess electricity to an auxiliary or "shunt" load, such as an electric water heater, when batteries are full. [7] Simple charge controllers stop charging a battery when they exceed a set high voltage level, and re-enable charging when battery voltage drops back below that level.