Search results
Results from the WOW.Com Content Network
In computer networking, the maximum transmission unit (MTU) is the size of the largest protocol data unit (PDU) that can be communicated in a single network layer transaction. [1]: 25 The MTU relates to, but is not identical to the maximum frame size that can be transported on the data link layer, e.g., Ethernet frame.
Router metrics help the router choose the best route among multiple feasible routes to a destination. The route will go in the direction of the gateway with the lowest metric. A router metric is typically based on information such as path length , bandwidth , load , hop count , path cost, delay , maximum transmission unit (MTU), reliability and ...
802.5 Token Ring can support frames with a 4464-byte MTU, FDDI can transport 4352-byte, ATM 9180-byte and 802.11 can transport 7935-byte MTUs. The IEEE 802.3 Ethernet standard originally mandated support for 1500-byte MTU frames, 1518 byte total frame size (1522 byte with the optional IEEE 802.1Q VLAN/QoS tag). The IEEE 802.3as update ...
It is designed to overcome bufferbloat in networking hardware, such as routers, by setting limits on the delay network packets experience as they pass through buffers in this equipment. CoDel aims to improve on the overall performance of the random early detection (RED) algorithm by addressing some of its fundamental misconceptions, as ...
The process is repeated until the MTU is small enough to traverse the entire path without fragmentation. As IPv6 routers do not fragment packets, there is no Don't Fragment option in the IPv6 header. For IPv6, Path MTU Discovery works by initially assuming the path MTU is the same as the MTU on the link layer interface where the traffic originates.
The TCP should ask the IP for the Maximum Datagram Data Size (MDDS). This is the MTU minus the IP header length (MDDS = MTU − IPHdrLen). When opening a connection, TCP can send an MSS option with the value equal to: MDDS − TCPHdrLen. In other words, the MSS value to send is: MSS = MTU − TCPHdrLen − IPHdrLen
Autonegotiation can be used by devices that are capable of more than one transmission rate, different duplex modes (half duplex and full duplex), and different transmission standards at the same speed (though in practice only one standard at each speed is widely supported).
The option value is derived from the maximum transmission unit (MTU) size of the data link layer of the networks to which the sender and receiver are directly attached. TCP senders can use path MTU discovery to infer the minimum MTU along the network path between the sender and receiver, and use this to dynamically adjust the MSS to avoid IP ...