Search results
Results from the WOW.Com Content Network
The new 7-mm .277 Fury round will be deployed both in an infantry battle rifle as well as in a dedicated machine gun and exemplifies the requirement of the much higher chamber pressure, 80-90,000 PSI Vs 55-60,000 PSI in the older ammunition required to attain the demanded ballistic performance with a 7-mm bullet in both weapon systems.
Drawings of various types of semiwadcutter bullets 4-cavity Keith semiwadcutter bullet mold, the Lyman 358429. The semiwadcutter design consists of a roughly conical shape with the tip truncated flat (called a meplat), sitting on a cylinder (A at right). The base of the cone is slightly smaller in diameter than the cylinder, leaving a sharp ...
C.I.P. uses a drilled case to expose the pressure transducer directly to propellant gases. The piezo measuring device (transducer) is positioned at a distance of 25 millimetres (0.98 in) from the breech face when the length of the cartridge case permits that, including limits.
Davide Pedersoli & C. is an Italian firearms manufacturing company based in Gardone Val Trompia, Italy, that was founded in 1957 by Davide Pedersoli. [1] Davide Pedersoli specializes in CNC-engineered black-powder weapon replicas for hunting, marksmanship and reenactment. Its weapons normally are more expensive than its competitors, but they ...
Components of a modern bottleneck rifle cartridge. Top-to-bottom: Copper-jacketed bullet, smokeless powder granules, rimless brass case, Boxer primer.. Handloading, or reloading, is the practice of making firearm cartridges by manually assembling the individual components (metallic/polymer case, primer, propellant and projectile), rather than purchasing mass-assembled, factory-loaded ...
By design, fully jacketed projectiles have less capacity to expand after contact with the target than a hollow-point projectile or a soft-point projectile.While this can be an advantage when engaging targets behind cover, it can also be a disadvantage as an FMJ bullet may pierce completely through a target, leading to less severe wounding, and possibly failing to disable the target.
However, the ammo was much heavier (393 gr (25.4 g) for 7.62 x 51 round compared to 160 gr (10.4 g) for .45 ACP), effectively limiting the ammo load. Additionally, when fired in full automatic mode free recoil delivered by full-sized and full-powered cartridges became an issue, too.
The .475 Linebaugh was first announced in the May 1988 issue of Guns & Ammo in an article written by Ross Seyfried. In 1991, Linebaugh announced a 1.6 inch variant of the .475 Linebaugh for use in converted Ruger .357 Maximum revolvers. This cartridge is known as the .475 Linebaugh Long or .475 Linebaugh Maximum, and produces somewhat greater ...