Search results
Results from the WOW.Com Content Network
The multiplication factor, k, is defined as (see nuclear chain reaction): k = number of neutrons in one generation / number of neutrons in preceding generation . If k is greater than 1, the chain reaction is supercritical, and the neutron population will grow exponentially.
The four-factor formula, also known as Fermi's four factor formula is used in nuclear engineering to determine the multiplication of a nuclear chain reaction in an infinite medium. Four-factor formula: k ∞ = η f p ε {\displaystyle k_{\infty }=\eta fp\varepsilon } [ 1 ]
The following apply for the nuclear reaction: a + b ↔ R → c. in the centre of mass frame, where a and b are the initial species about to collide, c is the final species, and R is the resonant state.
It served both purposes in the Molten-Salt Reactor Experiment (MSRE) at the Oak Ridge National Laboratory. The 2:1 molar mixture forms a stoichiometric compound, Li 2 [BeF 4 ] ( lithium tetrafluoroberyllate ), which has a melting point of 459 °C (858 °F), a boiling point of 1,430 °C (2,610 °F), and a density of 1.94 g/cm 3 (0.070 lb/cu in).
The mere fact that an assembly is supercritical does not guarantee that it contains any free neutrons at all. At least one neutron is required to "strike" a chain reaction, and if the spontaneous fission rate is sufficiently low it may take a long time (in 235 U reactors, as long as many minutes) before a chance neutron encounter starts a chain reaction even if the reactor is supercritical.
In nuclear engineering, the void coefficient (more properly called void coefficient of reactivity) is a number that can be used to estimate how much the reactivity of a nuclear reactor changes as voids (typically steam bubbles) form in the reactor moderator or coolant. Net reactivity in a reactor depends on several factors, one of which is the ...
Fission product yields by mass for thermal neutron fission of U-235 and Pu-239 (the two typical of current nuclear power reactors) and U-233 (used in the thorium cycle). This page discusses each of the main elements in the mixture of fission products produced by nuclear fission of the common nuclear fuels uranium and plutonium.
Whereas more classical thermal conversion has been considered with the use of a radiation/boiler/energy exchanger where the X-ray energy is absorbed by a working fluid at temperatures of several thousand degrees, [25] more recent research done by companies developing nuclear aneutronic fusion reactors, like Lawrenceville Plasma Physics (LPP ...