Search results
Results from the WOW.Com Content Network
Universal Host Controller Interface (UHCI) is a proprietary interface created by Intel for USB 1.x (full and low speeds). It requires a license from Intel. It requires a license from Intel. A USB controller using UHCI does little in hardware and requires a software UHCI driver to do much of the work of managing the USB bus. [ 2 ]
The Open Host Controller Interface (OHCI) specification was defined by a consortium of companies (Compaq, Microsoft, and National Semiconductor) as open specification to support USB 1.0 devices. The Universal Host Controller Interface (UHCI) refers to a specification that Intel originally defined as a proprietary interface to support USB 1.0 ...
Host Controller Interface or Host controller interface may refer to: Host Controller Interface (FireWire), an interface that enables a FireWire host controller to communicate with a driver; Host Controller Interface (USB), an interface that enables a USB host controller to communicate with a driver; Host Controller Interface (Bluetooth) in ...
If the USB host is restarted, the enumeration process is repeated for all connected devices. The host controller directs traffic flow to devices, so no USB device can transfer any data on the bus without an explicit request from the host controller. In USB 2.0, the host controller polls the bus for traffic, usually in a round-robin fashion. The ...
USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions USB 3.0 host controller (xHCI) provides hardware support for streams
The idle line state is when the device is connected to the host with a pull-up on either D+ (for full speed USB 1.x) or D− (for low speed USB 1.x), with transmitter output on both host and device is set to high impedance (hi-Z) (disconnected output). A USB device pulls one of the data lines high with a 1.5 kΩ resistor.
To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...
The USB mass storage device class (also known as USB MSC or UMS) is a set of computing communications protocols, specifically a USB Device Class, defined by the USB Implementers Forum that makes a USB device accessible to a host computing device and enables file transfers between the host and the USB device. To a host, the USB device acts as an ...