Ads
related to: air hose nozzles high pressure
Search results
Results from the WOW.Com Content Network
Convergent nozzles accelerate subsonic fluids. If the nozzle pressure ratio is high enough, then the flow will reach sonic velocity at the narrowest point (i.e. the nozzle throat). In this situation, the nozzle is said to be choked. Increasing the nozzle pressure ratio further will not increase the throat Mach number above one.
The simplest single fluid nozzle is a plain orifice nozzle as shown in the diagram. This nozzle often produces little if any atomization, but directs the stream of liquid. If the pressure drop is high, at least 25 bars (2,500 kPa; 360 psi), the material is often finely atomized, as in a diesel injector.
A fog nozzle. A fog nozzle is a firefighting hose spray nozzle that breaks its stream into small droplets.By doing so, its stream achieves a greater surface area, and thus a greater rate of heat absorption, which, when compared to that of a smoothbore nozzle, speeds its transformation into the steam that smothers the fire by displacing its oxygen.
A fire hose (or firehose) is a high-pressure hose that ... withstand the pressure of external air when a vacuum has formed inside. ... pumper to the nozzle. This hose ...
Applied using eductor or compressed air foam system (CAFS) and pumped through fire hose to a foam nozzle (or sometimes a less-effective fog nozzle). Attack hose (Attack line) A use classification of a fire fighting hose connected to output of a pump or other pressure source (e.g., gravity). Fire hose used to apply water or other fire fighting ...
This is referred as overexpanded flow because in this case the pressure at the nozzle exit is lower than that in the ambient (the back pressure)- i.e. the flow has been expanded by the nozzle too much. [13] A further lowering of the back pressure changes and weakens the wave pattern in the jet.
Similar to the garden hose example, plug nozzles use a shaped rocket nozzle with a poppet-shaped plug to allow the pattern of the rocket exhaust to be changed. This is used to adjust for changes in altitude; at lower altitudes the plug is pulled back to cause the exhaust to spread out, while at higher altitudes the lower air pressure will cause ...
When afterburning engines are equipped with a C-D nozzle the throat area is variable. Nozzles for supersonic flight speeds, at which high nozzle pressure ratios are generated, [2] also have variable area divergent sections. [3] Turbofan engines may have an additional and separate propelling nozzle which further accelerates the bypass air.
Ads
related to: air hose nozzles high pressure