Search results
Results from the WOW.Com Content Network
This normally takes between 0.1 and 0.5 seconds after the power supply is switched on. The signal is then sent to the motherboard, where it is received by the processor timer chip that controls the reset line to the processor.
The lack of a proper reset ability could otherwise possibly render the device useless after a power loss or malfunction. User initiated hard resets can be used to reset the device if the software hangs, crashes, or is otherwise unresponsive. However, data may become corrupted if this occurs. [6]
Higher temperatures and longer power-off time will shorten battery cell life. When replacing the battery cell, the system time and CMOS BIOS settings may revert to default values. Unwanted BIOS reset may be avoided by replacing the battery cell with the PSU power switch turned on and plugged into an electric wall socket.
The RSA-II requires a 20-pin cable to attach to the motherboard of the server. Without this cable the remote video facilities will still work, and if the external USB cable is connected, the remote keyboard and mouse will work—but nothing else (including power control) will function properly.
Fully integrated BMC as a single chip on a server motherboard. The baseboard management controller (BMC) provides the intelligence in the IPMI architecture. It is a specialized microcontroller embedded on the motherboard of a computer – generally a server. The BMC manages the interface between system-management software and platform hardware.
They are typically used to set up or configure printed circuit boards, such as the motherboards of computers. The process of setting a jumper is often called strapping. [citation needed] A strapping option is a hardware configuration setting usually sensed only during power-up or bootstrapping of a device (or even a single chip). [1]
Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything is securely connected to the wall and device. 3. Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure ...
Starting with the 80-conductor cable defined for use in ATAPI5/UDMA4, the master Device 0 device goes at the far-from-the-host end of the 18-inch (460 mm) cable on the black connector, the slave Device 1 goes on the grey middle connector, and the blue connector goes to the host (e.g. motherboard IDE connector, or IDE card).