Search results
Results from the WOW.Com Content Network
Structure of an Ethernet packet, including the FCS that terminates the Ethernet frame [1] A frame check sequence (FCS) is an error-detecting code added to a frame in a communication protocol. Frames are used to send payload data from a source to a destination.
A frame is a series of bits generally composed of frame synchronization bits, the packet payload, and a frame check sequence. Examples are Ethernet frames, Point-to-Point Protocol (PPP) frames, Fibre Channel frames, and V.42 modem frames. Often, frames of several different sizes are nested inside each other.
This frame may cause a collision at the remote end which cannot be detected by the transmitter, so the frame is not resent on the physical layer. Due to interference on the medium, its data is corrupted and frame check sequence fails, requiring recovery at a higher layer, if possible. [citation needed]
Protection against errors, generally by means of generating and checking frame check sequences; Control of access to the physical transmission medium; In the case of Ethernet, the functions required of a MAC are: [3] receive/transmit normal frames; half-duplex retransmission and backoff functions; append/check FCS (frame check sequence)
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
Ethernet packet. The SFD (start frame delimiter) marks the end of the packet preamble. It is immediately followed by the Ethernet frame, which starts with the destination MAC address. [1] In computer networking, an Ethernet frame is a data link layer protocol data unit and uses the underlying Ethernet physical layer transport
It is defined in RFC 1990. It can be used, for example, to connect a home computer to an Internet Service Provider using two traditional 56k modems, or to connect a company through two leased lines. On a single PPP line frames cannot arrive out of order, but this is possible when the frames are divided among multiple PPP connections.
The end of a frame is signaled by a valid frame check sequence followed by loss of carrier or by a special symbol or sequence in the line coding scheme for a particular Ethernet physical layer, so the length of the frame does not always need to be encoded as a value in the Ethernet frame. However, as the minimum payload of an Ethernet frame is ...