Search results
Results from the WOW.Com Content Network
Conductivity or specific conductance of an electrolyte solution is a measure of its ability to conduct electricity. The SI unit of conductivity is siemens per meter (S/m). Conductivity measurements are used routinely in many industrial and environmental applications as a fast, inexpensive and reliable way of measuring the ionic content in a ...
κ is the measured conductivity (formerly known as specific conductance), [3] c is the molar concentration of the electrolyte. The SI unit of molar conductivity is siemens metres squared per mole (S m 2 mol −1). [2] However, values are often quoted in S cm 2 mol −1. [4]
Electrical conductivity of water samples is used as an indicator of how salt-free, ion-free, or impurity-free the sample is; the purer the water, the lower the conductivity (the higher the resistivity). Conductivity measurements in water are often reported as specific conductance, relative to the conductivity of pure water at 25 °C.
In the following table, material data are given with a pressure of 611.7 Pa (equivalent to 0.006117 bar). Up to a temperature of 0.01 °C, the triple point of water, water normally exists as ice, except for supercooled water, for which one data point is tabulated here. At the triple point, ice can exist together with both liquid water and vapor.
Charge carrier density, also known as carrier concentration, denotes the number of charge carriers per volume. In SI units, it is measured in m −3. As with any density, in principle it can depend on position. However, usually carrier concentration is given as a single number, and represents the average carrier density over the whole material.
The condosity of any given solution is defined as the molar concentration of a sodium chloride (NaCl) solution that has the same specific electrical conductance as the solution under test. [1] [2] [3] By way of example, for a 2 Molar potassium chloride (KCl) solution, the
2 S is a gas at room temperature, despite hydrogen sulfide having nearly twice the molar mass of water. The extra bonding between water molecules also gives liquid water a large specific heat capacity. This high heat capacity makes water a good heat storage medium (coolant) and heat shield.
The following molar volumes and densities for the majority of the gaseous elements were calculated from the van der Waals equation of state, using the quoted values of the van der Waals constants. The source for the van der Waals constants and for the literature densities was: R. C. Weast (Ed.), Handbook of Chemistry and Physics (53rd Edn ...