Search results
Results from the WOW.Com Content Network
Formerly made of rope, typically of braided stainless steel wire, occasionally solid metal rod. Stem: a continuation of the keel upwards at the bow where the two sides of the hull meet. Stern: the aftmost part of a boat, often ending in a transom. Stern sheets a flat area or deck, inboard of the transom in a small boat. It may contain hatches ...
A girt is a vertically aligned girder placed to resist shear loads. Small steel girders are rolled into shape. Larger girders (1 m/3 feet deep or more) are made as plate girders, welded or bolted together from separate pieces of steel plate. [2] The Warren type girder replaces the solid web with an open latticework truss between the flanges ...
A hull is the watertight body of a ship, boat, submarine, or flying boat. The hull may open at the top (such as a dinghy), or it may be fully or partially covered with a deck. Atop the deck may be a deckhouse and other superstructures, such as a funnel, derrick, or mast. The line where the hull meets the water surface is called the waterline.
A steel ship's hull may be considered a structural beam with the main deck forming the upper flange of a box girder and the keel forming the lower strength member. The main deck may act as a tension member when the ship is supported by a single wave amidships, or as a compression member when the ship is supported between waves forward and aft. [2]
Hogging is the stress a ship's hull or keel experiences that causes the center or the keel to bend upward. Sagging is the stress a ship's hull or keel is placed under when a wave is the same length as the ship and the ship is in the trough of two waves.
A rolled steel girder is a girder that has been fabricated by rolling a blank cylinder of steel through a series of dies to create the desired shape. These create standardized I-beam and wide flange beam [7] shapes up to 100 feet in length. A plate girder is a girder that has been fabricated by welding plates together to create the desired ...
On modern yachts, standing rigging is often stainless steel wire, Nitronic-50 stainless steel rod or synthetic fiber.Semi-rigid stainless steel wire is by far the most common as it combines extreme strength, relative ease of assembling and rigging with reliability.
Frames support the hull and give the ship its shape and strength. In wooden shipbuilding, each frame is composed of several sections, so that the grain of the wood can follow the curve of the frame. Starting from the keel, these are the floor (which crosses the keel and joins the frame to the keel), the first futtock , the second futtock , the ...