enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Starter (engine) - Wikipedia

   en.wikipedia.org/wiki/Starter_(engine)

   An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.

3. Engine tuning - Wikipedia

   en.wikipedia.org/wiki/Engine_tuning

   Engine tuning is the adjustment or modification of the internal combustion engine or Engine Control Unit (ECU) to yield optimal performance and increase the engine's power output, economy, or durability. These goals may be mutually exclusive; an engine may be de-tuned with respect to output power in exchange for better economy or longer engine ...

4. Crankshaft position sensor - Wikipedia

   en.wikipedia.org/wiki/Crankshaft_position_sensor

   A crank sensor (CKP) [1] [2] [3] is an electronic device used in an internal combustion engine, both petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine parameters.

5. Twist-beam rear suspension - Wikipedia

   en.wikipedia.org/wiki/Twist-beam_rear_suspension

   The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.

6. Ignition system - Wikipedia

   en.wikipedia.org/wiki/Ignition_system

   As batteries became more common in cars (due to the increased usage of electric starter motors), magneto systems were replaced by systems using an induction coil.The 1886 Benz Patent-Motorwagen and the 1908 Ford Model T used a trembler coil ignition system, whereby the trembler interrupted the current through the coil and caused a rapid series of sparks during each firing.

7. Slider-crank linkage - Wikipedia

   en.wikipedia.org/wiki/Slider-crank_linkage

   Next, the extended position of the slider needs to be determined. From the pivot point of the crank arm, draw a new crank arm coincident with the ground level axis but in a position closest to the slider. This position should put the new crank arm at an angle of 180 degrees away from the retracted crank arm.

8. Crankshaft - Wikipedia

   en.wikipedia.org/wiki/Crankshaft

   Crankshaft, pistons and connecting rods for a typical internal combustion engine Marine engine crankshafts from 1942 The crankshaft is located within the engine block and held in place via main bearings which allow the crankshaft to rotate within the block. [3]

9. Cold start (automotive) - Wikipedia

   en.wikipedia.org/wiki/Cold_start_(automotive)

   A cold start can be difficult for an engine due to higher viscosity of oil and fuel in cold temperatures. Generally speaking, diesel engines have more difficulty starting at low outside temperatures than gasoline engines, and electric engines have the most problems. Diesel engines do not use spark plugs to ignite the air fuel mixture and rely ...