enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Swivel (drill rig) - Wikipedia

   en.wikipedia.org/wiki/Swivel_(drill_rig)

   A Swivel is a mechanical device used on a drilling rig that hangs directly under the traveling block and directly above the kelly drive, that provides the ability for the kelly (and subsequently the drill string) to rotate while allowing the traveling block to remain in a stationary rotational position (yet allow vertical movement up and down the derrick) while simultaneously allowing the ...

3. List of components of oil drilling rigs - Wikipedia

   en.wikipedia.org/wiki/List_of_components_of_oil...

   Drill bit (#26) is a device attached to the end of the drill string that breaks apart the rock being drilled. It contains jets through which the drilling fluid exits. Drill floor (#21) is the area on the rig where the tools are located to make the connections of the drill pipe, bottom hole assembly, tools and bit. It is considered the main area ...

4. Kelly drive - Wikipedia

   en.wikipedia.org/wiki/Kelly_drive

   Simple diagram of a drilling rig and its basic operation. The kelly drive is #19. A kelly drive is a type of well drilling device on an oil or gas drilling rig that employs a section of pipe with a polygonal (three-, four-, six-, or eight-sided) or splined outer surface, which passes through the matching polygonal or splined kelly (mating) bushing and rotary table.

5. Bottom hole assembly - Wikipedia

   en.wikipedia.org/wiki/Bottom_hole_assembly

   Rotary assemblies [2] are commonly used where formations are predictable and the rig economics are an issue. In such an assembly the weight of the drill collars gives the BHA the tendency to sag or flex to the low side of the hole, collar stiffness length and stabiliser diameter and placement are engineered as a means of controlling the flex of the BHA.

6. Combination gun - Wikipedia

   en.wikipedia.org/wiki/Combination_gun

   The earliest combination guns were called swivel guns, (not to be confused with the more widely known small cannon that is mounted on a swiveling stand or fork and allows a wide range of motion) which used a set of barrels designed to rotate to allow either the rifled or the smoothbore barrel to line up with a flintlock mechanism before firing. [2]

7. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.