Search results
Results from the WOW.Com Content Network
To promote TAK-4i intelligent independent suspension system suspension, Oshkosh has stated the following: “In fact, Independent testing proves that the Oshkosh L-ATV provides the same ride quality at speeds 70 percent faster than today’s industry gold standard for off-road mobility, the Oshkosh MRAP All-Terrain Vehicle (M-ATV).” [9]
The Tilting Suspension System [27] (also known as the Leaning Suspension System) is not a different type or geometry of construction; moreover, it is a technology addition to the conventional suspension system. This kind of suspension system mainly consists of independent suspension (e.g., MacPherson strut, A-arm (double wishbone)). With the ...
A multi-link type rear independent suspension on an AWD car. The anti-roll bar has some yellow paint on it. Independent suspension is any automobile suspension system that allows each wheel on the same axle to move vertically (i.e. reacting to a bump on the road) independently of the others.
The vertical volute spring suspension system is a type of vehicle suspension system which uses volute springs to compensate for surface irregularities. This type of the suspension system was mainly fitted on US and Italian tanks and armored fighting vehicles starting from throughout the 1930s up until after the end of the Second World War in 1945.
An active suspension is a type of automotive suspension that uses an onboard control system to control the vertical movement of the vehicle's wheels and axles relative to the chassis or vehicle frame, rather than the conventional passive suspension that relies solely on large springs to maintain static support and dampen the vertical wheel movements caused by the road surface.
Automotive suspension design is an aspect of automotive engineering, concerned with designing the suspension for cars and trucks. Suspension design for other vehicles is similar, though the process may not be as well established. The process entails Selecting appropriate vehicle level targets; Selecting a system architecture
Independent suspension systems offer the advantage of lower unsprung mass to improve roadholding, and when properly designed, the ability to maintain the roadwheels perpendicular to the road surface during cornering and in response to uneven road surfaces, further improving roadholding. The reduction in transfer of vertical undulations in road ...
The moving parts of the system, e.g., suspension strut or steering ram, are sealed by contact seals between the cylinder and piston for tightness under pressure. The other plastic/rubber parts are return tubes from valves such as the brake control or height corrector valves, also catching seeping fluid around the suspension push-rods.