Search results
Results from the WOW.Com Content Network
A Voltage controller thyristor based dimmer rack An electrical schematic for a typical SCR-based light dimmer. A voltage controller, also called an AC voltage controller or AC regulator is an electronic module based on either thyristors, triodes for alternating current, silicon-controlled rectifiers or insulated-gate bipolar transistors, which converts a fixed voltage, fixed frequency ...
Compared to a rheostat-based circuit, the use of a thyristor greatly increases efficiency, as far less waste heat is generated. Dimming lights with a solid state dimmer also reduces total power draw, unlike rheostat dimmers. Spira's design (and most modern dimmers) rely on the use of AC power, and on the characteristics of incandescent lights.
The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1] The "quick-break" switch overcame the problem of a switch's contacts developing electric arcing ...
The switch is controlled by a PWM (Pulse Width Modulation) signal, which alternately turns the switch on and off at a rapid rate. The relative proportion of off time vs. on time determines brightness. For example, if the switch is off 10% of the time, the resulting control signal would be the equivalent of 1 V produced with a variable resistor.
EMS-1 (The ITEC Electronic Modular Switch is an electronic direct control switching system. The modules are combined to form a complete switch or any of the modules can be added to your present Step-by-Step Systems.) EMS-2 (The EMS-2 RURAL SWITCH is a stored program control analog switch designed to be cost-effective in small exchanges.
An analogue switch: Maxim MAX313. An analogue switch, also called a bilateral switch, is an electronic component that behaves in a similar way to a relay, but has no moving parts. The switching element is normally a pair of MOSFET transistors, one an N-channel device, the other a P-channel device. The device can conduct analog or digital ...
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
Circuit switching is a method of implementing a telecommunications network in which two network nodes establish a dedicated communications channel through the network before the nodes may communicate. The circuit guarantees the full bandwidth of the channel and remains connected for the duration of the communication session. [1]